Lol double weight savings?
Printable View
Lol double weight savings?
So I finally got out there tonight. Taking no chances, and resurfaced all mounting surfaces on the lower plenum. A belt sander would have made life much easier... :(
http://img.tapatalk.com/d/13/11/28/qyruzyru.jpg
http://img.tapatalk.com/d/13/11/28/y3ysevug.jpg
Got the plenum mounted back up, and 5 of the nozzles sealed in tight with some thread sealant. Unfortunately I can not find the FU#*%*^@##?! last one anywhere. :Dismal: I think it was lost in the truck when I took it to see if I could find a better solution to the slip connection. No luck there as the snow system has the filter built in the nozzles. After checking, rechecking, screaming, checking again, everywhere NO LUCK!
There are snow dealers close, about 6, so hopefully 1 is open Friday.
Oh, got the new recirc attachment swapped out, so that is ready. Friday is the annual Turkey bowl at work, a flag football game that turns into destruction derby for the body, but after that the plan is to seek out the nozzle, bleed the clutch (again), and go over the exhaust system to be sure there is no leaks pre-wide band creating my afr issues.
Quick question on the NB O2's. Does the richer afr's equal a higher voltage reading? Trying to see if the NB's are in line with the WB.
^ Yes, .9 to 1v is rich (WOT) territory.
Glad to see the progress! Seems like every step forward = two steps back on these things. :lol:
Tell meh!
Copied over from my chrome thread:
No performance shop around has the snow nozzle, and holder I need to finish putting it back together. I ordered it tonight. That is the bad. The good is while searching around for them I found this site The Best Water injection system and water methanol injection systems at AlcoholInjectionSystems.com. I will be most likely swapping for their nozzles in the future.
I found this check valve there as well which will be going in at the distro box.
https://lh4.googleusercontent.com/-e...n_check_11.jpg
Oh, and I finally found a digital EGT gauge. Only one I have every come across...
https://lh5.googleusercontent.com/-6...PLXD0120-2.jpg
Will wait on that for another time. So after searching endlessly the holdup is $40 in a nickle plated connector, and a nozzle. Football kick my ass royally today, and I am supposed to be helping JBurhman install his Evo trans in the am. Unsure if will be able to get in the truck at this point...
Updates :suspect:
Beans?
http://2.bp.blogspot.com/-LicHHxGaIu...1676523_n.jpegQuote:
Originally Posted by Jimvr4
Yeah, um, well, uh, you see, there was this time at band camp...
Work, wife, n life has been brutal on my shop time.
Sent from the CaveMan Cave!
:lol: You could put that phrase on T-shirts and fund your entire build.Quote:
Originally Posted by CoopKill