What did you do today to your 3/S?

Quote:

---

Originally Posted by sergechronos

Could just sell blue prints or something. Even at like $15-20, worth the time and material savings for others.

---

True true.


Btw. while having a good pic. That box thing in the corner what's that for? Want to know if I should delete :p

I have no idea yet, I need to research it because mine is horrifically rusted and likely non-op.

I'll look into later today.

ECS G sensor

Quote:

---

Originally Posted by anyonebutme

ECS G sensor

---

Should've figured someone would know it off hand, thanks ABM. Well, mine is getting deleted then, as is the Wiring for it. Need to get off my ass and do the wiring harness stuff, so much to go through still to find my grounding issues and what not.

is it only for the ECS? Does the ABS/SRS system use it also? I'll need to look over the wiring again as I can't remember off the top of my head if any other system use it.

Quote:

---

Originally Posted by fastfalcon94

I posted this on the other thread a few days ago. But I finished my custom seat brackets. My corbeau RRS seats now sit a little lower than the factory seats:)

http://i1192.photobucket.com/albums/...psgaq9vfsi.jpg


http://i1192.photobucket.com/albums/...psoaub2rka.jpg

http://i1192.photobucket.com/albums/...pslobqhhk8.jpg

http://i1192.photobucket.com/albums/...psgqpfgg8g.jpg

---

You going to make these available to others?

I don't think I am going to get into the seat bracket business. There would be liability involved, and some of my bends were achieved with a vice and hammer. This was my design pic though before I started. I think the only tweaking I did was with the front inner bracket. It doesn't overlap like in the pics, it just welds onto the front. You basically make the actual rectangle frame part first. Use some shims to get it to sit exactly where you would want in the car. Then see what you need for feet. I think I have about $25 in material into them.

Edit: and the square box thing on the drivers side is some kind of factory part. not sure what it is exactly.



http://i1192.photobucket.com/albums/...psw9zjvefh.jpg



And here is what I mean by make the rectangle first. You can see how much lower it sits than the corbeau brackets. Put it where you want, cut/bend the feet, tac them on.


http://i1192.photobucket.com/albums/...ps02lxinzc.jpg

Quote:

---

Originally Posted by fastfalcon94

I don't think I am going to get into the seat bracket business. There would be liability involved, and some of my bends were achieved with a vice and hammer.

---

Maybe you could do some sort of disclaimer like "For show cars only. Not intended for on or off road use." :D

Quote:

---

Originally Posted by green-lantern

Maybe you could do some sort of disclaimer like "For show cars only. Not intended for on or off road use." :D

---

"This product also known to the state of California to cause cancer."

Thanks for the info to eld I'll try it hopefully won't mess that up. I know I have to calibrate my needles now


Sent from my iPhone using Tapatalk