Well, I've had a steady stream of contractors and such coming through today to evaluate the pipe issue. Specialist coming tomorrow to basically scope the area and see exactly where the leak is occurring, but a few contractors think they can get to the leak by removing the cabinetry in the kitchen and cutting through the floor there rather than tearing the garage up.
Didn't get much done in the garage because of that, maybe 45 minutes or so wire wheeling the engine bay a bit. Going to fill in holes and stuff tomorrow and try to get the bay done. Thinking that if I have to move the car, I MAY try dropping the car down onto some wood that is resting right on the concrete and just jacking up each end individually to shove it over. Time consuming, but pretty much what ends up happening if the moving dollys break. No time to order metal wheel skates or anything and have them shipped here.
On the bright side, I am moving closer towards getting all my bushings done in poly. Just a handful left to go.
