What did you do today to your 3/S?

Well..let's see: bought a series2 ecu, sold some stuff, going to pick up a four bolt block and some other stuff Thursday.

Hoping t have some time this weekend to pull out the remaining crap in the engine bay and get stuff cleaned off under the car for the coating.

Been trying to find alternatives to paying $170 for the super pro bushing for the control arm..looks more and more like pouring my own is my only option. Found an evo1-6 bushing that might've worked, but has a metal shell, and you'd already have to keep the factory metal outer shell in place as well so idk. Beyond that, some pan hard bar bushings that were reasonably close, but..meh. Need to measure bushings for the rear subframe and order the ninja AWS delete. Been hard to keep quiet about it, saw it a while back. Very high quality ish.

Quote:

---

Originally Posted by CoopKill

But foglights

---

Bill riddle me this. What is BELOW the foglight switch?

Quote:

---

Originally Posted by 2fnloud

Bill riddle me this. What is BELOW the foglight switch?

---

LOL it has been soooooo long since I have had the privilege of driving her to know! :lmao:

Pop-up headlight switch on 1st gen and a blank on 2nd gens.

Ahh yes, I have my blank replaced with a switch already...

Quote:

---

Originally Posted by DrGonzo

Pop-up headlight switch on 1st gen and a blank on 2nd gens.

---

Blank you say?

https://fbcdn-sphotos-h-a.akamaihd.n...fa551986f5e59e

Got the flashable pulled out of the car, pretty much as far as I made it. Still have to get the wires out of the OBD1 port, but otherwise it's ready to go to its new home.

Still trying to get parts sold, but GPU fan took a shit on my desktop and the waterblock I ordered to replace it and add to water cooling loop doesn't fit despite manufacturer saying it would so I'm stuck using my laptop to get shit done. Bad time for projects and shit for school stuff. Going tomorrow morning to pick up the four bolt block that'll get built eventually. Hoping to get ahead on HW so that I can spend this weekend getting everything else ready to coat everything, but unlikely to happen. On the bright side, the list of parts I need/want to buy for this rebuild keeps shrinking. AWS, ABS delete and poly bushings are the main things left aside from the trans rebuild. Anything else would just be gravy.

Figured out my flash ecu has the 02 sensor wires/jumper swapped internally. Swapped the wires on my boomslang harness for front and rear 02 as well as replaced both older 02s with fresh Densos. And all is good. :) Now I'm just hoping I can make it work nicely with my ARC2 - I'm going to give it a good effort.

Got some fresh looking TD04 DNP 02 pipes and BC 264s in the mail.

Made a wire harness for my SSI-4 to pull in my 3x AEM gauge's output into the innovate log chain I already have with the other 3x Innovate gauges.

Quote:

---

Originally Posted by 2fnloud

Blank you say?

https://fbcdn-sphotos-h-a.akamaihd.n...fa551986f5e59e

---

Yeah, that is a blank switch on bottom. Looks like you converted it for something else.

facepalm.