My LCD screen project, boost, WBO2, Knock, etc

Install mockup #2 lot to do to get it positioned right.

http://a4.sphotos.ak.fbcdn.net/hphot...02896213_n.jpg

THAT is going to be awesome Alan, I am really liking this option. Will you please document it well?

Are you going to use black ABS plastic to create a faceplate?

I hope to remember to take pic when/if I get the fitment correct.

I plan to make a face from the same stuff I used for my AFC install. Custom AFC mount and Oil Preasure guage install

Nice, ABS could give you the texture but a smooth accent will work just as well.

I tried to use a blade but found it much easier to use nibblers......

http://www.allelectronics.com/mas_as...9/2/f/2351.Jpg

Quote:

---

Originally Posted by tfw a-ok

Just finish my test install in a junk yard cluster. It wasn't as easy as I imagined. I think I like the fuller display though.

Before anybody asks, the cluster is laying back in this picture so the tach needle is floating.

http://i13.photobucket.com/albums/a2...10_LCDTACH.jpg

---

http://sphotos.xx.fbcdn.net/hphotos-...18245658_n.jpg
http://sphotos.xx.fbcdn.net/hphotos-...46478490_n.jpg

Alright I got all the wiring done but have a few questions about the screen installation. Where did you use clear silicon? LCD to gauge face, or to the plastic cluster? Also, did you guys grind the honeycomb behind the gauge face all the way down or did you leave some to help hold/support the LCD?

Thanks! I'm excited to get this together and try it out :)

I used epoxy to glue it to the gauge face, and I cut/ground all the honeycomb plastic out. Not needed for support...

I haven't seen it mentioned anywhere yet, but is there support for the Omni 4 Bar map sensor yet? If not, I can find the scaling for it. I just ordered one since I got a 96+ intake manifold w/the map sensor spot on it.