What did you do today to your 3/S?

Quote:

---

Originally Posted by Sin'sVr4

started my aws delete today. got the kit from pampena and everything is great on it. Tore everything out, all the lines, pump, lines under the car and was pretty easy. followed the 3sx directions and took me about 1 hour 40 minutes to get it out of the car and strip the lines off. Didnt have a 1/2" drill bit or drill so didnt finish putting it back in. needed teflon tape (couldnt find my roll) so could put the plugs in the rack. but went to the store, got some ps fluid, teflon tape and more cans of brake cleaner. will finsh up on tues when im off. heres some pics of the project

---

Nice looking car in that AWS delete FAQ ain't it?

;)

-Chris

Quote:

---

Originally Posted by boosted3s

Ive been very busy finishing up school and just recently the car bug bit me hard. Decided to wash the car today for the first time in months and here's the result.

http://i149.photobucket.com/albums/s...psb1c6e647.jpg

Then I decided since I had some plastidip laying around I'd do the cowl.

Before

http://i149.photobucket.com/albums/s...ps645de4cc.jpg

After

http://i149.photobucket.com/albums/s...psfbce44b0.jpg

I'm going to pull a part tomorrow to get new window motor/regulators since both mine went out and possibly get a 94 front end for later installment. I also plan on removing my sails on my next day off and plastidiping under them since they trim is fading.

---

Get some screw caps to clean that up even more.

Quote:

---

Originally Posted by mb3000

If you hate them that much, just run a water to air. Re-locate or drop down the battery and install a 90deg. intercooler in it's place. Run the rear turbo in the usual route across the belt side of the engine, then across the front of the engine to meet up with the front turbo.

---

You trying to change his mind again? lol

Quote:

---

Originally Posted by green-lantern

You trying to change his mind again? lol

---

:lol: Just figured I'd throw it out there.

Got a new Welding Helmet

http://sphotos-a.xx.fbcdn.net/hphoto..._1020960_n.jpg

Tested it out and made somethings I've been wanting to make.. IT WORKS AWESOME!!

...This is using my little 90$ 90AMP Harbor Freight Flux Core welder.

http://sphotos-b.xx.fbcdn.net/hphoto...00849476_n.jpg


http://sphotos-b.xx.fbcdn.net/hphoto...66420938_n.jpg

Chris is that an exhaust split?

Shhhhh!!! or maybe a COLLECTOR shhhh tho!! :)

Friday
http://i1148.photobucket.com/albums/...ps613192e5.jpg

Saturday
http://i1148.photobucket.com/albums/...ps6e8fa7c9.jpg
And today it runs!!!!!!!!!

^^^ nice job...

...but that reminds me, i need a windshield washer bottle :lol:

I got a few I could sell. I think I have them listed at $10 plus shipping.