CoopKill's Mistress Makeover Thread [Pic Heavy]

Quote:

---

Originally Posted by CoopKill

Uh OH! What me do?

---

Improper (or) failed notification of engine installation...

...i think its rule #2 of the charter by-laws!





















:p

Quote:

---

Originally Posted by wingnut

Improper (or) failed notification of engine installation...

...i think its rule #2 of the charter by-laws!





















:p

---

Oh you are sly! You are sly! I thought he knew the week before it was a done deal this weekend... OOoops!

Quote:

---

Originally Posted by CoopKill

https://lh3.googleusercontent.com/-Z...1368955654.jpg

---

Bad ass :)

I thought we where friends!

Quote:

---

Originally Posted by vr4tune

I thought we where friends!

---

I did too, and you did not show up! :p

Getting close!

Quote:

---

Originally Posted by vr4tune

I thought we where friends!

---

Quote:

---

Originally Posted by CoopKill

I did too, and you did not show up! :p

---

Get a room and kiss and make up already.... freaking bromance

Quote:

---

Originally Posted by jbuhrman

Get a room and kiss and make up already.... freaking bromance

---

He's too old for me!

Quote:

---

Originally Posted by CoopKill

Progress! Nathan made the epic trip down to help out! Just about ready to go in. Just a few things to button up, and should have
the clutch, and trans on tomorrow. Got the meth lines all routed, and in place. All the water lines are handled. Need to get 2 cap bolts tomorrow for the rear fuel rail, and will be able to get the intake back on. Will prolly wait till next weekend to get it in the bay. I need to do some prep in there first. (Fuel, egr delete, some clutter cleanup).

https://lh4.googleusercontent.com/-d...1111982057.jpg

---

I might have missed it but have you looked into the temp rating of those meth lines? It gets a little toasty in that valley.

Quote:

---

Originally Posted by CoopKill

OK....... Soooooooo......

The parts I ordered last week did not ship last week. :sad: Trans bearing MIGHT make it by Friday, but the cam bolts are coming in from the east coast. They only had 10 in stock. :die:

I got side tracked while test fitting the lower intake, fuel lines, and upper intake to map where the meth/water nozzles are to be mounted. It goes to the fab shop tomorrow.

:suspect:
https://lh5.googleusercontent.com/-X...2256927224.jpg
https://lh5.googleusercontent.com/-K...1229500583.jpg

Once I get it done in aluminum, or stainless it will be going to the coaters. Thinking carbon fiber match.

Wanted to see it in something other than white

https://lh6.googleusercontent.com/-p...0/31773682.jpg

If I do go with the cf look I may add to it to cover the valve cover bolt holes. Hrmmmm...

---

Love it. Now to stalk your posts to see how you did this!