What did you do today to your 3/S?

Dreamed about my plans for it.

Drove to work. Had some fun on the back road behind the office.

-John

welded on my balance tube fittings, damn the front one is a tight fit with the way the ets pipe runs. I hope I can get the fan back in.

Quote:

---

Originally Posted by Forest Gump

welded on my balance tube fittings, damn the front one is a tight fit with the way the ets pipe runs. I hope I can get the fan back in.

---

Surging issues or something?

Quote:

---

Originally Posted by AdamVR4

Surging issues or something?

---

typical part throttle pressure pulsing that td04s and fmic usually do. Nothing too serious, just want to make the car run as smooth as possible.

Quote:

---

Originally Posted by J_Parker

Re-located my battery into the hatch, installed FPR, finished the MAF-less tune with my E-Manage Blue, polished my intercooler/piping again, did a bit of a wire tuck, and started planning/mocking up my twin GT-35R build.

Also determined that my rings are going, so I'm going to throw some thicker oil in, in the meantime and build my other engine up along with the turbo kit.

---

twin 35r's? on what a stroker?

Quote:

---

Originally Posted by Forest Gump

welded on my balance tube fittings, damn the front one is a tight fit with the way the ets pipe runs. I hope I can get the fan back in.

---

Maybe I am weird, but I kind of like the sound of my TD04's surging, sounds like I have a DJ stuck under my hood trying to mix up some beats.....

Beauty of speed density...

Just wanted to let everyone know, baking the lower throttle body (FIAV) in the oven did infact kill it. Car wanted to stall for the first 20 seconds and then proceeded to idle at 3k rpms, and I could only adjust it down to 2500 rpms. Swapped my spare FIAV on, used the same IAC, and it idled like a champ.

Quote:

---

Originally Posted by sublime_whatigo

Sell me 2 of your shiny tips for cheap.

Also just finished working on these.
http://i21.photobucket.com/albums/b2...25_112copy.jpg
http://i21.photobucket.com/albums/b2...33_341copy.jpg
Thanks to Rakuny for powdercoating and sourcing the new shiny hardware hiding in the background.

---

Found a little time to wire in my MAP sensor and adapter to the harness. Slowly but surely this thing will get going.

http://dl.dropbox.com/u/168836/2012-...2018.59.47.jpg

Installed my new idle air controller motor, now to see if it does something!