Installed my dual walbro 400s in tank, fabb'd a stay bracket to the transmission mount and my cross pipe for my single turbo, plumbed fuel line from the tank to the engine bay.
Printable View
Installed my dual walbro 400s in tank, fabb'd a stay bracket to the transmission mount and my cross pipe for my single turbo, plumbed fuel line from the tank to the engine bay.
are you using a stock modified hanger? i wanna upgrade to those bad boys when my smaller walbros give out lol. is there a size difference between the 255 and that 400?Quote:
Originally Posted by arm0red1
Installed the front bumper and modified the ducting for the FMIC setup. Short list of items left:
-front door speakers
-New rubber antenna
-paint exterior faded trim pieces
-pick up new oil drain plug and install (will have to run without oil temp gauge until adapters come)/.finish oil change
-clamp catback exhaust to adapter flange and bolt to downpipe
-hook up negative battery cable
-Wait for AEM to come back after repair and calibrate widebands/plug in, set base timing, TUNE.
http://sphotos.xx.fbcdn.net/hphotos-...06798972_n.jpg Motor Mounts and Eibach camber bolts.
http://sphotos.xx.fbcdn.net/hphotos-...51169485_n.jpg Getting Turbos mocked up
http://a1.sphotos.ak.fbcdn.net/hphot...05495200_n.jpg Cleaned garage
http://a6.sphotos.ak.fbcdn.net/hphot...78138124_n.jpg Go fast corner, lots of special parts in ze red tool box...
http://a4.sphotos.ak.fbcdn.net/hphot...02201270_n.jpg Parked the very dirty race car in it!
This finally off, Borla on.
[IMG]http://i153.photobucket.com/albums/s...lywheel015.jpg[/IMG]
Tore down 2 trannys and cleaned and resealed them after putting in new OS's. bolted up the new tranny, deleted the clutch booster, put in a mechanical clutch master cylinder, pulled some vac hoses not needed anymore. Bolted the brakes back up, installed the billet tcase and DS. Just need to bleed the brakes, and clutch. Bought a new shorty intake manifold and will have that going in on wed! Have a bew UP racing short throw shifter coming in next week also. So much done!!
This came in the mail today.
http://img.photobucket.com/albums/v3...425121806a.jpg
Very happy.
Sell me 2 of your shiny tips for cheap.Quote:
Originally Posted by 1stStealthN/A
Also just finished working on these.
http://i21.photobucket.com/albums/b2...25_112copy.jpg
http://i21.photobucket.com/albums/b2...33_341copy.jpg
Thanks to Rakuny for powdercoating and sourcing the new shiny hardware hiding in the background.
got about 20 mins of run time on her today. started making some valvetrain fuss. shit, time to go back in and adjust them solid lifters!!! should be fun.
guys dont get them. nothing but headaches.
Installed new tie rod ends