Printable View
slammed a pothole on the passenger side of the car and now my drivers side front tire is severally out of alignment! i think in ~70 miles i wore it down so badly that i needs to be replaced. so now i gotta spend all the money i saved up for dyno tuning on a new tire and 4 wheel alignment. Murphy’s law strikes again.
Hmm...Now thats dedication... And sounds like a really fun time with a couple hotties involved!!!... Ok time to hop over to the not so work safe side of this site lol!!
Installed new lower intake after drilling out The mounting holes as the japanese-spec lower intake (6g74) doesn't fit directly to the 6g72 heads. Then found that the drivers side intake doesn't fit as advertised. So going to see if I can find some one local to fix that, as I don't think my welder has the omph for that thick of aluminum.
Ericc...
did some more electrical work to the lower dash harness.... wishing i could drive my car :(
Why I had to drop the trans... Today I went digging. Problem is pretty obvious. Fused the pressure plate, clutch disc, and the flywheel together on my 7000rpm launch stunt.
http://i788.photobucket.com/albums/y...3s/photo23.jpg
http://i788.photobucket.com/albums/y...3s/photo12.jpg
http://i788.photobucket.com/albums/y...o3s/photo1.jpg
Never again with an ACT. Time for Tilton :)
Took my WHOLE front sub frame apart, stripped it, and will be painting it soon. I do however need all new hardware for it, including a steering rack. After roughly 12 years of not being apart it was quite tricky tearing it down, I had to CUT the endlinks for my swaybar off, and beat just about every bolt out with my 30oz. But it all came apart in the end. Hopefully after a good clean and repaint it'll never get to be like that again.
Ouch!Quote:
Originally Posted by J. Fast
Exedy FTMFW!!
Pulled the spyder out of the driveway to make room for another guys 3000gt. We swapped his clutch and put in some motor mounts. Worst motor mounts I've ever seen. Every time he shifted the engine made a horrible clunk chunk chunk sound.
He's a new member and just really struggling and couldn't afford to get it fixed. Considered selling the car just because he couldn't afford the clutch swap.
such a kind gentleman you are Gearheadvr4... if i only had people in canada that would've helped me with my shit.. Good job sir! :)Quote:
Originally Posted by Gearheadvr4