Look for an EGT kit that produces a 0-5v signal, such as the HKS EGT, or Stinger EGT. If you find one that is not supported, I'll add it to the LCDBC software.Quote:
Originally Posted by Unlogic
Printable View
Look for an EGT kit that produces a 0-5v signal, such as the HKS EGT, or Stinger EGT. If you find one that is not supported, I'll add it to the LCDBC software.Quote:
Originally Posted by Unlogic
I noticed the plastic on the DC power jack connector is getting hard and brittle with age and crumble when you press hard between your fingers. I'd suggest everyone to upgrade to this DC power jack, the plastic is more pliable, and the wire gauge that it comes with is more than adequate. $2.09 US shipped. This 2 meter (6 feet) DC power extension cable has two ends, when you cut this cable, leave a couple inches and save the other end for a future project. When I tested my cable, the color was correct, red for positive (inside tip), black for ground (outside tip). You can test this by putting a multi-meter probe on the outside tip and test if there is low resistance between it and the black wire.
https://i.ebayimg.com/images/g/1UYAA...AM/s-l1600.jpg
This morning I spent some time figuring out or solving the annoyance Evoscan has. That is, if you wanted to use the custom 3000GT EFI for our cars, it would disappear when you choose 1g/12pin connector menu option. Anyhow, the problem is solved, and I included the LCDBC's Boost, WBO2, External sensors 1-4 also.
Download and follow instructions contained inside:
http://lcdbc.xp3.biz/updates/EvoscanFiles.zip
I've got a flash/update list a mile long, Antero. :D
And if that file is already in there just replace it with this file?
Yes that is right.Quote:
Originally Posted by 2fnloud
Antero-
I haven't kept up with whether you've altered your original manual to reflect all the improvements you've made.
Is there a new(er) version for me to DL and print?
The one I have is a few years old...
Version 3.40 -- it's already a bit dated too. :)
http://lcdbc.xp3.biz/EBC-Revision3.40.pdf
Antero,
If an external Pressure sensor is used, will the LCD display the vacuum? Will it display a - PSI?
Yes that is correct. :)Quote:
Originally Posted by 2fnloud