My LCD screen project, boost, WBO2, Knock, etc

Quote:

---

Originally Posted by mazzerman

I went for this one, Pressure Transducer or Sender 100 PSI Stainless Steel for Oil Fuel Air Water | eBay and the wiring is straightforward, from the sensor there is red for power black for ground and blue for signal which goes to EXT1 or EXT2 on the LCDBC with the same wiring nearly red to red black to black and blue to the remaining wire (cant remember which one it was) then in the config just choose 100 PSI oil sensor, easiest install iv ever done

---

Sweet, just installed mine last night, cant wait to install the oil pressure sensor, will probably go with same one you got.

http://www.lcdbc.xp3.biz

Version 3.35 allows you to disable the tune alert.

Thanks !! Now to remember how the hell I update the unit again lol


Sent from my dog n bone

https://youtu.be/GqsOJq1i0ok

Some people are having a challenge on how to unplug the connector correctly, so I made a short video demonstrating.

I've plugged/unplugged this test LCD screen, perhaps over 200 times without accidentally separating a wire from the crimped pin. The trick is not to let one wire do all the work when pulling, instead grab all wires simultaneously by squeezing tightly and then rock the connector back and fourth until it finally disconnects. I suppose a safer method would be to take a small flat head screw driver and pry the connector from the extreme edges where it mates/locks.

Hi blackstealth,

I did the update to disable tuner alert but unit
Now seems very sluggish and laggy throwing up loads of random knock counts. Is there a way to undo a recent update ?

Cheers


Sent from my dog n bone

Quote:

---

Originally Posted by fastbikes76

Hi blackstealth,

I did the update to disable tuner alert but unit
Now seems very sluggish and laggy throwing up loads of random knock counts. Is there a way to undo a recent update ?

Cheers


Sent from my dog n bone

---

Maybe reload the previous version?

Something to try until Antero weighs in...

I would if I knew how lol


Sent from my dog n bone

Quote:

---

Originally Posted by fastbikes76

I would if I knew how lol


Sent from my dog n bone

---

Ah, hmm.

Don't have the link to the site handy...try this:

http://www.lcdbc.xp3.biz

Find the last version that worked for you - or any other version, I suppose, DL it, and load 'er.

Assuming the above posts indicate you're prolly running 3.35?

Pick one preceding it. :wink:

Yes you can go back to any previous version without issue.

Quote:

---

Originally Posted by fastbikes76

I would if I knew how lol


Sent from my dog n bone

---

Any luck yet, Elton?