Blackmount
07-03-2012, 03:24 PM
Hey guys i need a little bit of help with my new MAF Translator.
For starters.
For my Load Source, when I have it set to MAF+RPM, WOT it never goes higher then about 140% shouldnt it go higher then that? Its also very erratic, it is all over the place
When i set my Load Source to TPS its steady but reads really high, at idle like 40% and WOT it peaks 320% ish but still stable, now which should i choose?
Next.
When i am monitoring Hz (maf flow signal) at it is also very unsteady while under heavily throttle, idk about WOT, but i assume it does the same. I was about to get off the highway when i figured it out and theres no where that i can rip the car open after that.
NOTE: the HZ signal acts the same as when i have my load source to MAF/RPM its erractic
So do u guys think its a BAD MAF or MAF over run?
I am running the 607 MAF which is 2G DSM
I have made no adjustments or corrections yet.
For starters.
For my Load Source, when I have it set to MAF+RPM, WOT it never goes higher then about 140% shouldnt it go higher then that? Its also very erratic, it is all over the place
When i set my Load Source to TPS its steady but reads really high, at idle like 40% and WOT it peaks 320% ish but still stable, now which should i choose?
Next.
When i am monitoring Hz (maf flow signal) at it is also very unsteady while under heavily throttle, idk about WOT, but i assume it does the same. I was about to get off the highway when i figured it out and theres no where that i can rip the car open after that.
NOTE: the HZ signal acts the same as when i have my load source to MAF/RPM its erractic
So do u guys think its a BAD MAF or MAF over run?
I am running the 607 MAF which is 2G DSM
I have made no adjustments or corrections yet.