View Full Version : A question for RPS clutch owners
JohnnyTurbo
06-08-2012, 12:44 AM
I picked up a car for my stepson with an RPS Max Series Clutch w/6-Puck Disc and it grabs right off of the floor, is this normal for an RPS clutch? My white VR4 with the SPEC stage 3+ clutch grabs about 1/4 the way off the floor and it feels normal compared to this one.
aaronatstate
06-08-2012, 12:50 AM
It's the 6 puck causing it. My RPS Max Street engages normally. Just a heavier pedal feel than stock.
lawdogg
06-08-2012, 12:51 AM
My RPS Maxx pressure plate w/ OEM clutch disc always grabbed right on the floor. Actually, I ran two of them and they both did it. Without adjusting the pedal. But I'm weird and prefer the on-the-floor engagement.
Rakuny
06-08-2012, 09:54 AM
I'm running RPS maxx with oem disc as well and it engages normally.. The clutch pedal had to be adjusted after it was installed. maybe that's what it needs?
anyonebutme
06-08-2012, 10:25 AM
Yep, sounds like the pedal needs adjusted.
Sin'sVr4
06-08-2012, 05:21 PM
i have a RPS stage 4 6puck unsprung and it engages normally. Id say pedal adjustment or bad TOB
JohnnyTurbo
06-08-2012, 08:36 PM
TOB gives no signs of being bad, so I doubt that is it. A disc of whatever design should make no difference, a .240" disc is a .240" disc whether a paddle design or full plate. Pedal adjustment makes more sense, so any write ups out there on the procedure?
Rom3BreaK
06-09-2012, 03:03 PM
I believe I heard some years ago that this was a common problem with RPS clutches. I also think there WAS some kind of solution - might be a bit difficult to find but if you search the other site you may be able to find the thread. IIRC somebody came up with some sort of spacer but I could be totally wrong. Step 1 of course is checking the pedal adjustment.
Edit: found thread
http://www.3si.org/forum/f116/rps-max-clutch-engagement-fix-388445/
I have noticed some people have problems with the RPS max clutches engaging very close to the floor since the pressure plate is so stiff. My pedal would engage right off the floor with no adjustment left to raise the engage point. I used a DSM fix to make the pedal engage in it's stock location.
All i did was shim the fork ball out with two washers and re-adjust the clutch pedal. My car shifts like a dream now! I was actually slipping the clutch at first because I had been driving with the clutch engaging right off the floor for so long I had to get use to the new feel.
This should work for other upgraded pressure plates also- But I know it works like a champ for the RPS MAX PP.
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.