PDA

View Full Version : Planning an Exhaust System



hdorre
05-22-2012, 07:49 AM
Okay, so the goal of this exhaust system will be for it to be deep and relatively loud.

Id remove the stock muffler, and install a 2.5" inlet and dual 2.5" outlet Dynomax Ultra-Flo Welded muffler in its place. From there, Id run 2.5" piping to each side of the car. On each side of the car, Id have dual 3" non resonated tips.

Should this be a good setup for what I want? What would you change?

Im having guys at a shop do this. Im bringing the muffler and tips to the guys. For tips, I was thinking of getting 4 of these (http://www.summitracing.com/parts/SUM-690042/) and having the guys weld them into pairs.

Do you guys have any recommendations?

nodoze
05-27-2012, 08:42 PM
if you do alittle lookig theirs on ebay theirs weld on tips from a corvette that are slightly staggered that flow well with the body lines

Turbo Beast
05-27-2012, 08:54 PM
V-band clamps, get em. You will regret it if you don't.

Personally I'm not a fan of real loud exhausts, but to each his own, go for it and post a vid!

stealthee
05-27-2012, 08:57 PM
You really are not going to acheive a deep sound with a DOHC.

dpartinvr4
05-28-2012, 12:36 AM
http://www.youtube.com/watch?v=7n89z7kpuIQ
it's deep and throaty, quiet when you want it to be, loud when you want it to be. the video really doesn't do it justice at all, but you kinda get the idea.

ictponder
06-13-2012, 12:49 AM
That Dynomax is going to sound like garbage TBH

Get a Flowmaster 80 Series Crossflow muffler w/factory resonator. Get rid of the catalytic converter but don't use a test pipe. Instead, use another resonator, your local shop should have something that will fit 2.5". I used to have a test pipe and although it sounded good at idle, it sounds like garbage at higher RPM. The 2nd resonator will keep the tone and control the raspy wet fart sound when you go WOT. I would also not recommend going with side pipes as you will get a loud clappy sound as opposed to a nice deap "wubwub" sound, just go straight pipes from the rear resonator to the back of the car. I also went with the 3sx downpipe but didn't really notice a huge difference in sound after adding it. I will try to post a link of my exhaust tomorrow and maybe give you a better idea. Please do not use a Dynomax.

hdorre
06-14-2012, 11:52 PM
if you do alittle lookig theirs on ebay theirs weld on tips from a corvette that are slightly staggered that flow well with the body lines I just looked online, and youre right. I can imagine them flowing well.


V-band clamps, get em. You will regret it if you don't.

Personally I'm not a fan of real loud exhausts, but to each his own, go for it and post a vid!
Im looking at the clamps online now. Thanks! Ill be sure to post one.



http://www.youtube.com/watch?v=7n89z7kpuIQ
it's deep and throaty, quiet when you want it to be, loud when you want it to be. the video really doesn't do it justice at all, but you kinda get the idea. That exhaust sounds great on video.


That Dynomax is going to sound like garbage TBH

Get a Flowmaster 80 Series Crossflow muffler w/factory resonator. Get rid of the catalytic converter but don't use a test pipe. Instead, use another resonator, your local shop should have something that will fit 2.5". I used to have a test pipe and although it sounded good at idle, it sounds like garbage at higher RPM. The 2nd resonator will keep the tone and control the raspy wet fart sound when you go WOT. I would also not recommend going with side pipes as you will get a loud clappy sound as opposed to a nice deap "wubwub" sound, just go straight pipes from the rear resonator to the back of the car. I also went with the 3sx downpipe but didn't really notice a huge difference in sound after adding it. I will try to post a link of my exhaust tomorrow and maybe give you a better idea. Please do not use a Dynomax.

Why do you think that the Dynomax is going to sound like garbage? Have you heard one before on a 3000GT or Stealth? The only reason Im asking this is because Dynomax and Magnaflow have been recommended time and time again for n/a 3000GTs on forums.

So, youre saying to replace the cat with a resonator? Wont I fail emissions?

mb3000
06-15-2012, 12:34 AM
I need to get a video of mine. One of the deepest I've heard on a 3/s.

hdorre
06-15-2012, 01:52 AM
I need to get a video of mine. One of the deepest I've heard on a 3/s.

What are you running? Oh, and are you n/a?

IPD
06-15-2012, 06:31 AM
rather stupid to do on n/a, imho. and people who want an exhaust such as you describe don't drive their cars with any frequency. those who have usually end up looking for something a little less rattling on their brains. it's also ricey as heck to open up the exhaust on a car that makes such a low amount of HP to begin with.

if you want deep & loud, 2.5" single shot will do it--i promise you that. heck, just eliminating the cats will make your exhaust loud.

MeTarzan
06-15-2012, 09:13 AM
Single shot 3" exhaust no muffler with 2 resinators, one in the stock cat location and one closer to the rear = very deep and growling tone...wish I had a video but heard it at the track once.

mb3000
06-15-2012, 09:40 AM
What are you running? Oh, and are you n/a?

VR4, catless 3.5" turbo back splitting into two Apexi N1's.

hdorre
06-15-2012, 10:35 AM
rather stupid to do on n/a, imho. and people who want an exhaust such as you describe don't drive their cars with any frequency. those who have usually end up looking for something a little less rattling on their brains. it's also ricey as heck to open up the exhaust on a car that makes such a low amount of HP to begin with.

if you want deep & loud, 2.5" single shot will do it--i promise you that. heck, just eliminating the cats will make your exhaust loud.
Ive read that it'd sound either awesome or horrible. I really dont want to take the chance. When you say eliminate cats, do you mean replace it with a test pipe?


Single shot 3" exhaust no muffler with 2 resinators, one in the stock cat location and one closer to the rear = very deep and growling tone...wish I had a video but heard it at the track once.
Ive seen vids, but hate the look of of a single shot :(


VR4, catless 3.5" turbo back splitting into two Apexi N1's.
Woah.. $$ Im only in highschool :D

Should I just ditch my original idea, and get either 3sx or OBX headers.. possibly with a test pipe? Thisll almost definitely help me performance wise; but how would it affect the sound?

IPD
06-15-2012, 02:01 PM
Ive read that it'd sound either awesome or horrible. I really dont want to take the chance. When you say eliminate cats, do you mean replace it with a test pipe?


Ive seen vids, but hate the look of of a single shot :(


Woah.. $$ Im only in highschool :D

Should I just ditch my original idea, and get either 3sx or OBX headers.. possibly with a test pipe? Thisll almost definitely help me performance wise; but how would it affect the sound?

if you want "performance", catless single-shot is the way to go. period. it won't do that much for N/A...but that's as good as you can ask for.

stealthee
06-15-2012, 05:11 PM
Catless helps a good bit on a NA, but you want to make sure to have some kind of resonator or it will sound like ass. I dropped .25 in the 1/4 with just the addition of a test pipe.

IPD
06-15-2012, 05:42 PM
agreed. i don't know if any single shot's DON'T have a resonator....because of that reason.