PDA

View Full Version : Part # needed for the starter solenoid wiring connectors.



DanEboy5
05-07-2012, 09:12 PM
I have the click click fix harness made by Joe(Bye Bye STi). I would like to make a couple more for some local guys and have an extra. I went to Napa, Carquest, bumper to bumper, Pep Boys, Radio-Shack, Best Buy, Shockwave and NOBODY has the plugs either the male or female connectors.

So, anybody know the part #'s or a place to get them? I will try Fastenal tomorrow as a final place.

Thanks....Dan

Chris@Rvengeperformance
05-07-2012, 10:17 PM
I find that normal 1/4" spade connectors fit pretty tight and you can then just tape it up to hold it securely.

Mine were a little corroded anyway so I cut them off and just soldered right to the old wiring. It is still pretty easy to reverse. I have an extra positive battery cable and starter solenoid wire bundle if you need one.

DanEboy5
05-07-2012, 10:27 PM
Thanks Chris. I was trying to make them easy for anyone to install. I may just go with the spade type connectors.