PDA

View Full Version : could use some insight into a lifter tick question



hotGTO
09-20-2010, 05:27 PM
My TT lifter tick gets crazy loud then almost silent then crazy loud and it seems random... I know there is a solution to fix the tick, but why is the racket so random?

blindmist
09-20-2010, 05:33 PM
You have sludge most likely. Change the oil and use CD2 Oil detergent in place of a quart of oil. Go drive for about an hour. You will smile.

Just to be safe though, when they get loud, is your oil pressure normal?

hotGTO
09-20-2010, 06:38 PM
I have found that with heavier weight oil the oil pressure stays more stable and oil leaks less often, so I use a high viscosity full synth, and I just did an oil change to that from a water thin but very clean Mobile One that the PO used... on his oil, pressure would drop to near zero at idle, and lifter tick would be loudest after a long drive when parking, Now on my 20W 50 Castrol full synth I have not done the long drive yet, but on the short warm up and test drive the tick went from GONE to LOUD to quiet then loud then gone then quiet again... all while parked after a short test drive on the heavy synth... Oil pressure stayed higher and more constant on the heavier oil...

Gonna drive a good 60 miles or so tonight and see how she sounds throughout...

hotGTO
09-20-2010, 06:42 PM
PS, I also know that pressures run low at idle anyway, and the the stock guage is far from accurate. That's why I am not quite panicking at the low oil pressure yet...

mikeyVR4
09-20-2010, 07:23 PM
Yeah lifter tick is random and comes and goes which is a good thing because a constant noise can result to a more complex issue. Your oil pressure should never drop to 0 or the minimum line on your gauge, even at idle.

Solution? Get some 99 Lifters. 3SX is selling them for dirt cheap right now so you should try to grab some, I did ;).

http://www.3sx.com/store/comersus_viewItemBundle.asp?idProduct=12153

blindmist
09-20-2010, 07:25 PM
Save some money on shipping.

http://cgi.ebay.com/ebaymotors/91-99-MITSUBISHI-3000GT-LIFTERS-LASH-ADJUSTERS-6G72-_W0QQcmdZViewItemQQhashZitem45f553ce62QQitemZ30046 8653666QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccesso ries#ht_2909wt_1165

VR4
09-20-2010, 08:38 PM
lose the 20w50 and run a high quality HDEO in a proper viscosity and a good filter.


dont make me explain why. i no longer have the time or patience.

Austin@STM
09-20-2010, 08:59 PM
I have been running Brad Penn all season and havent had a single tick out of it this year, used to get it here and there last year with the Eneos.

-Austin@STM

Sin'sVr4
09-20-2010, 09:10 PM
I am using Rotella-t 15w-40. Colorado has extreme heat/cold diferences and is actually rec's to use 20-50! Mine never ticks, ....but im using 99 lifters ;)

OhioSpyderman
09-20-2010, 09:14 PM
Curious as to the price per quart...

Bob.

Austin@STM
09-20-2010, 09:17 PM
Brad Penn is $6.50 a qt

OhioSpyderman
09-20-2010, 09:21 PM
Brad Penn is $6.50 a qt

Does that include SEX????

Bob. :)

Sin'sVr4
09-20-2010, 09:23 PM
$3.59 for Rotella t 15w-40. I love this oil

http://www.shell.com/home/Framework?siteId=rotella-en&FC2=/rotella-en/html/iwgen/products/zzz_lhn.html&FC3=/rotella-en/html/iwgen/products/triple_protection_detail.html

OhioSpyderman
09-20-2010, 09:27 PM
Tried it...hated it....now filling with Mobil One 10W40 High Mileage....WITH either a MOBILE ONE filter or K&N....

Bob.

mikeyVR4
09-20-2010, 10:57 PM
I am using Royal Purple 10w-30 and k&n oil filter.

Mr Faust
09-21-2010, 12:13 AM
I've been running Full Syth 15w-40 Rotella T with a quart of Lucas Pure Synth, still noisy as hell but they are the stock lifters, have 3rd gens sitting on the floor less than 5ft from me. :X too lazy

hotGTO
09-21-2010, 02:06 AM
I run HDEO in my Jeep... know all about the stuff, and all about the whole oil debate... I'm not really up for an oil debate. I run purolator pure one filters because they are the best I have found in my research, and I change oil very frequently. have used full synth 5w 30 HDEO 15w 40 full synth 20w 50, full synth 5 w 50, now back to the 20w 50... It works for my needs and keeps my oil pressure stable in my high mileage motor. I think the real answer is replace lifters ......

Primus101
09-21-2010, 03:50 AM
This is what the FSM has to say on this subject-

LASH ADJUSTER CHECK
NOTE
If the clanging noise due to the lash adjuster produced immediately
after the engine has started or during operation persists,
perform the following checks.
(1) Check the engine oil, and add or replace if necessary.

NOTE
(1) If the engine oil level is low, the air drawn in from
the oil strainer will be trapped in the oil passage.

(2) If the engine oil level is higher than the specified
level, agitation of the oil by the crankshaft could cause
a large amount of air to enter the oil.

(3) A deteriorated oil contains a large amount of air, because
the air, once trapped, is not readily separated
from the oil.

If the air trapped due to these causes enters the high
pressure chamber in the lash adjuster, the air in the high
pressure chamber will be compressed while the valve
is in the opened position. The lash adjuster will be drawn
too far in, and will produce noise when the valve closes.
This is the same phenomenon that occurs when the valve
clearance is adjusted to an excessive dimension.
In this case, the normal condition will be, restored if the
air escapes from the lash adjuster.

hotGTO
09-21-2010, 01:00 PM
This is what the FSM has to say on this subject-

LASH ADJUSTER CHECK
NOTE
If the clanging noise due to the lash adjuster produced immediately
after the engine has started or during operation persists,
perform the following checks.
(1) Check the engine oil, and add or replace if necessary.

NOTE
(1) If the engine oil level is low, the air drawn in from
the oil strainer will be trapped in the oil passage.

(2) If the engine oil level is higher than the specified
level, agitation of the oil by the crankshaft could cause
a large amount of air to enter the oil.

(3) A deteriorated oil contains a large amount of air, because
the air, once trapped, is not readily separated
from the oil.

If the air trapped due to these causes enters the high
pressure chamber in the lash adjuster, the air in the high
pressure chamber will be compressed while the valve
is in the opened position. The lash adjuster will be drawn
too far in, and will produce noise when the valve closes.
This is the same phenomenon that occurs when the valve
clearance is adjusted to an excessive dimension.
In this case, the normal condition will be, restored if the
air escapes from the lash adjuster.

Very interesting, and definitely good to know but that does not cover the problem of noisy lifters when you have proper oil level and fresh oil

MaxClass
09-21-2010, 10:29 PM
Don't know the particulars about this stuff but I have heard people rave about the results of doing a "SeaFoam" treatment on their cars. Especially to help clean out the engine and fuel system.

mb3000
09-21-2010, 11:01 PM
Don't know the particulars about this stuff but I have heard people rave about the results of doing a "SeaFoam" treatment on their cars. Especially to help clean out the engine and fuel system.

Correct me if I'm wrong, but I've always thought that introducing SeaFoam to a high milage car, that has not had any "high detergent" oil previously in the engine would screw it over. I'm thinking that the carbon that is built up around the worn piston rings is helping to maintain the seal, if removed, would create a problem. I'm probibly wrong, but I thought I would just throw it out there.

hotGTO
09-21-2010, 11:18 PM
Seafoam works great for cleaning carbon deposits, but not sure if I would expect it ro cure the lifter tick problem or not... my tick has seemed to have eased up a lot since my oil change. It's just funny how random it is. One great thing is that my oil pressure is greater an much more stable since increasing the oil viscosity! It was dropping to nothing at idle when hot, and would get up to half when cruising... now stays about 1/8 -1/4 at idle, and just over 1/2 at speed...