PDA

View Full Version : Brakes AWS delete kit, rear brake lines holding me up...



O_ROD
03-20-2012, 11:58 PM
Getting ready to delete my AWS but can't get those damn rear brake lines to break free... I tried pb blaster, heat and vice grips and they just don't want to budge, they are quite corroded and now nice and round. Is there another place I can disconnect the brake lines in order to drop the rear subframe? I wouldn't mind cutting the hardline and re-flaring it with a new 3/16" connection but taking the rounded one out will still be a bitch.

Thanks...

J. Fast
03-21-2012, 12:36 AM
Cut them with a pipe cutter so you get a clean cut and braze on new stainless JIC fittings. Nevermind fussing with the old stuff, just pull the line out of the manager just enough to make room to cut the brake lines clean. Sand down the cut 3/4" from the end with mesh emory cloth and sweat on a new fitting. Other option would be to use JIC crimp adapters or I suppose you could run all new braided lines, but that's really expensive because new lines are roughly $5.00 per foot

J. Fast
03-21-2012, 12:54 AM
Seriously, you can sweat a fitting onto every solid line on our cars just like a copper pipe fitting with a map gas torch and a visit to a Place like Pirtek or a Hydralic Plumbing supply company. IE, same kind of company that repairs lines on heavy equipment such as bobcats, backhoes, diesel engines, heavy industrial equipment and refrigerant lines etc... Places like that stock bins and bins of braise on fittings. I braised and hand bent a number of connections on both my racecar and my street car ranging from brake line adapters, oil lines, water lines, and power steering lines. I can post pics of what fittings you should use for sweating (if you'd like) and post some example pics of adapters I've braised that are currently in use.

O_ROD
03-21-2012, 11:28 AM
Seriously, you can sweat a fitting onto every solid line on our cars just like a copper pipe fitting with a map gas torch and a visit to a Place like Pirtek or a Hydralic Plumbing supply company. IE, same kind of company that repairs lines on heavy equipment such as bobcats, backhoes, diesel engines, heavy industrial equipment and refrigerant lines etc... Places like that stock bins and bins of braise on fittings. I braised and hand bent a number of connections on both my racecar and my street car ranging from brake line adapters, oil lines, water lines, and power steering lines. I can post pics of what fittings you should use for sweating (if you'd like) and post some example pics of adapters I've braised that are currently in use.

Good idea, pictures as a reference would really help me out if you don't mind.

Erron Spalsbury
03-21-2012, 11:44 AM
I really wouldn't do that man. Solder will expand and contract and a different rate than the steel. They will crack eventually. Put a flare fitting on. We're not talking about a fixing a radiator leak, this kind of leak could really be bad in a hurry.

O_ROD
03-23-2012, 10:08 PM
I ended up just cutting the lines at the old flare fitting. I'm going to re-flare and replace the rubber flex hose as well seeing as the old flare fitting simply will not come off of them.