View Full Version : (Another) hesitation/stalling post...
unrightentity
03-10-2012, 08:19 AM
So, after searching high and low, I can't find anything that directly covers my current issue. First things first; I have a '92 3000gt SL (DOHC 5spd) that has taken a liking to hesitating while cold, but drives totally normal when warmed up. The strange part is, the hesitation goes away completely after 4k RPM. Now, the stalling... warm or cold, the car will occasionally shut off if I'm at high rpm then go into neutral. It will try to idle at 750, then just drop down to 200. Sometimes it will correct itself out, but usually it just dies.The stalling only occurs when in neutral, and once in a while it will idle irradically while parked, which stops as soon as I disconnect the MAF. The MAF is spotless inside. Before I get a handful of "Dude, ECU!" posts, I just installed a rebuilt one after noticing a small leakage from a cap (Thanks to GZP for that, and sorry about my impatience!) and am doing plugs, wires and a few other odds 'n ends once I get my core back. Anything else I should check while I have the plenum off? I already intend on pulling my IAC and giving it a look over, but I read somewhere that rpm jumps while turning the wheel are a good indicator that it's responding, and it gains several hundred rpm. The engine is at 136k miles, had it's 120k service and looks clean as a whistle. Sorry if I missed a post covering this before and thanks in advance, everyone!
jake stealth
03-10-2012, 10:14 PM
My thoughts: Couple of things first. Get a service manual and read it, using the diagnostic procedure(s) and tests. It will save you tons of time as well as money. Secondly, diagnose the problem instead of just throwing parts at it.
It appears that you have two separate problems, which are probably unrelated.
By cold engine hesitations, I assume you are talking about the engine response (or lack of) as it relates to increases in throttle openings during light acceleration. Hesitations like this are usually caused by insufficient fuel and/or not enough spark advance, both of which are exacerbated when cold. Since your engine is operating normally under heavy loads at high engine speeds it tells us that several things are ok. Fuel volume requirement is greater at WOT at elevated rpm than at part throttle so your fuel supply from the tank through the injectors is probably ok – but spray patterns themselves might not be ok. The ignition system is probably ok since you are not experiencing a low rpm heavy load misfire (plugs and secondary wires) and you are not experiencing high rpm misfires at WOT either. The sparkplug voltage requirements are greater under WOT than at part throttle but they might be less at part throttle high rpm than at lower engine speeds under deeper throttle – the higher compression pressures equate to increased spark plug voltage requirements.
After disconnecting the MAF, the ECU senses a failure (check engine light) and provides the engine with a specific fuel and spark schedule and the ECU also ignores several sensor voltage inputs. If I remember correctly (probably wrong), it assumes a coolant temp of something like 160F and an air inlet temperature of about 80F and a throttle position sensor of ?? volts. When compared with a normally operating system, the spark timing gets retarded and the fuel schedule gets richened. Because of the retarded spark, throttle response becomes somewhat sluggish and the power is reduced. Not always, but generally speaking, if the engine operates more smoothly (less power) with the MAF disconnected it indicates a sensor failure or at least a false sensor input to the ECU.
Since your engines is operating poorly when cold and ok when at normal operating temperatures, you might be experiencing a temperature sensor anomaly input to the ECU. Colder temperatures call for additional fuel and more spark advance. I think the water temp sensor is located just below the coil pack so check the sensor for proper resistance both hot and cold. Take a look at the harness and the connector here as well.
The air temp sensor is located in the MAF as is the barometric sensor. There is a service manual procedure to check the resistance’s as they relate to the temperatures at hand. Also, check the MAF connector and wiring.
Engine idle problems might be caused by a sensor input or more likely a problem with the IAC motor or adjustments to the throttle body itself. These cars are a couple of decades old and trust me, if there is an exposed screw anywhere under the hood, some mechanic or some owner somewhere has turned it, regardless if it is off limits or not. Follow the service manual cleaning and adjustment procedure for the throttle body to get things back to spec.
It seems like a sensor is telling your ECU that your engine is warm, when in fact, it is still cold. As long as the sensor inputs to the ECU are within normal operating limits, no code will be generated. The fuel injectors might be clogged a little – enough volume but a lousy spray pattern.
Initial ignition timing at spec?
Good Luck – tell us what you find out.
Sorry for the rant - LOL
jake stealth
03-10-2012, 10:25 PM
One more thing - -if your engine has an EGR system make sure it's not opening when the engine is cold.
stealthee
03-10-2012, 11:26 PM
Quick explanation, if the car runs better with the MAF unplugged, then the MAF is most likely faulty. Replace that first.
You can test the IAC before you replace it.
You can test it while on the car.
All you need is a multimeter.
Test the continuity across the pins. There will be six pins, 3 in each row.
123
456
Test continuity across pins 1 and 2, pins 2 and 3, pins 4 and 5, and pins 5 and 6.
Continuity should be around 28-33 ohms if its an old style beige ISC.
If you get no continuity between any two pins then the ISC is shot.
If you find out yours is bad you can get one at rockauto.com for $72.79
More Information for STANDARD MOTOR PRODUCTS AC99 (http://www.rockauto.com/catalog/moreinfo.php?pk=446333) Its part number AC99
unrightentity
03-17-2012, 10:36 PM
That's greatly appreciated, both of you, and I definitely don't mind the rant! Lots of useful information as I get more properly aquanted with the vehicle. Unfortunately, Transmission issues will be putting these repairs on hold for a while, but I will at least run tests and see if I can't locate the issue. Will post results when I get it done.
Hans@GZP
03-19-2012, 10:24 AM
Unplug your ECS computer. It's located in the passenger side of the hatch area. Take out the cargo tray and remove the phillips screw holding the access panel on. The computer has 2 plugs. It will often make the car run bad at lower rpms.
another thought:
when the throttle body gets old, it can get sticky. this will hamper performance, as it makes the car seem slow to respond. cleaning it or rebuilding it can do wonders.
jake stealth
05-30-2012, 05:57 PM
Stealthee ole bud - -you are correct. Was dinking around with the Stealth and forgot to hook-up the maf plug. Engine idled fine but hesitated and backfired through the intact tract when opening the throttle with a cold engine. Don't know where my thought process was, perhaps it was on another vehicle type. It's been over twenty years. Me bad! Jake
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.