View Full Version : My Mod List - Quest to 450awhp on pump
VR-4 0wnz j00
10-23-2011, 05:33 AM
I just wanted to post my current mod list and what I have left to buy. Please give me any suggestions you may have. Some of them listed are suspension, which Im also upgrading. Im still going to be in Taiwan for another year, but I will install the suspension and catback when I come home in Dec.
Adjustable Rear Control Arms (3SX)
Topline Engineering Ground Kit
Hallman Pro RX Kit - Manual Boost Controller
IPS Motorsports - Walbro 255 Fuel Pump Kit
DSM 450cc blacktop injectors
52mm UNIVERSAL SINGLE GAUGE SWIVEL POD MOUNT HOLDER
AUTOMETER 6103 COBALT MECH BOOST VACUUM 30 PSI GAUGE
PRE-CAT CAT CATALYTIC MITSUBISHI 3000GT TURBO 94-99
DNP Downpipe Used
EVO MR BOV
EGR Blockoff Plates
3SX Custom High-Capacity Single-Pass Drop-In Radiator and Brackets
Rear Strut Mount Isolators
Fuel Rail Adapter Kit w Loop
Left to buy:
Billet DR-650's
KYB Struts
Tein S-tech springs
MAF Translator and 3/3.5in GM MAF
660cc injectors
M2 Exhaust
So far, for my mod list, Ive only spent ~1300. The only thing that sucks is its going to be another $3653.97 to finish off the rest of the mods, not including a SMIC/FMIC upgrade.
mb3000
10-23-2011, 01:06 PM
A fmic from cxracing wouldn't break the bank. PMP or Pampena seems to have the best prices.
gkeohan
10-23-2011, 03:29 PM
I did'nt see it listed but do you have an aftermarket fuel pressure regulator to cope with the upgraded fuel pump, or do you not need one. I'v never been to clear on that?
Bluejediz
10-23-2011, 03:40 PM
Billet DR-650's are insane turbos. Defintly what I would choose if I had the money.
But if your worried about the cost, then 15g's are half the price and would still get you to the 450whp on pump.
VR-4 0wnz j00
10-23-2011, 08:02 PM
Im actually not worried about the cost. Since I knew I would drive my car for a while, I started supporting mods first. I have the money to do it all now, but there is not point until Im back in the states for good. Just wondering if I left anything out. I'm hoping the FPR will be OK but if it gets overrun, then Ill get a AFPR.
JasonY
10-23-2011, 08:07 PM
Stock FPR will be fine.
Probably going to need more than 450 injectors though. They will be MAXED out in that hp range.
Jason
familyMAN
10-23-2011, 09:28 PM
Stock FPR will be fine.
Probably going to need more than 450 injectors though. They will be MAXED out in that hp range.
Jason
At least the 450's will help keep timing down, since he is running piggy back and trying for pump gas #s. Adding an adjustable FPR would dial in the 450's if 450awhp on pump is a "set in stone" goal.
mb3000
10-23-2011, 10:38 PM
Stock FPR will be fine.
Probably going to need more than 450 injectors though. They will be MAXED out in that hp range.
Jason
.....
I just wanted to post my current mod list and what I have left to buy. Please give me any suggestions you may have. Some of them listed are suspension, which Im also upgrading. Im still going to be in Taiwan for another year, but I will install the suspension and catback when I come home in Dec.
Adjustable Rear Control Arms (3SX)
Topline Engineering Ground Kit
Hallman Pro RX Kit - Manual Boost Controller
IPS Motorsports - Walbro 255 Fuel Pump Kit
DSM 450cc blacktop injectors
52mm UNIVERSAL SINGLE GAUGE SWIVEL POD MOUNT HOLDER
AUTOMETER 6103 COBALT MECH BOOST VACUUM 30 PSI GAUGE
PRE-CAT CAT CATALYTIC MITSUBISHI 3000GT TURBO 94-99
DNP Downpipe Used
EVO MR BOV
EGR Blockoff Plates
3SX Custom High-Capacity Single-Pass Drop-In Radiator and Brackets
Rear Strut Mount Isolators
Fuel Rail Adapter Kit w Loop
Left to buy:
Billet DR-650's
KYB Struts
Tein S-tech springs
MAF Translator and 3/3.5in GM MAF
660cc injectors
M2 Exhaust
So far, for my mod list, Ive only spent ~1300. The only thing that sucks is its going to be another $3653.97 to finish off the rest of the mods, not including a SMIC/FMIC upgrade.
http://www.3si.org/forum/f35/tech-my-take-injectors-vs-timing-control-vs-hp-stock-ecu-262353/
JasonY
10-23-2011, 10:39 PM
Missed that, saw he listed having 450's.
Jason
SnakeSkinner
10-24-2011, 02:12 PM
then 15g's are half the price and would still get you to the 450whp on pump.
Realy? I have never seen a stock motor 15G turbo car get anywhere close to that on pump gas. If your talking about a stock motor, piggy back car in most cases are are looking 400 or less on pump gas with 15g's. 15G cars have a car time making 450 awhp on race gas. That's is some really old school turbo tech.
guido1205us
10-24-2011, 04:22 PM
I did'nt see it listed but do you have an aftermarket fuel pressure regulator to cope with the upgraded fuel pump, or do you not need one. I'v never been to clear on that?
I'm running a Supra hard wired with stock fpr and I bounce at idle between 14.5 - 15.9. I'm told stock is fine but I wonder if this is lean at times. As I understand it, at wot I have plenty of fuel, but at idle the fpr is being overun which the ecu is trying to compensate, thus reducing flow and getting lean.
I have an AEM fpr that I'll install this winter as I'd like to just play it safe.
VR-4 0wnz j00
10-25-2011, 11:12 AM
mb3000 - thanks for the link. I will go with the stock FPR right now. It its a problem when I tune, then Ill throw on an adjustable. Im going with the billet DR-650's because I want the fastest spool with room for power. I want pump gas numbers because I will rarely run race gas. Im getting excited because I have a lot to install when I get home.
Chris@Rvengeperformance
10-25-2011, 02:51 PM
good choice
TT Eric
10-25-2011, 05:43 PM
660cc is too big for pump gas, you'll have timing induce knock, 550cc will be plenty enough.
Eric
VR-4 0wnz j00
10-25-2011, 08:38 PM
I thought with the MAF-T that I can set injector size so I dont have to worry about that.
JasonY
10-25-2011, 09:46 PM
...If it were only that simple.
Good news is, you can save some money getting inexpensive 550's instead of the 660's.
Jason
HellBringer
10-25-2011, 10:01 PM
Stock FPR is perfectly fine. 550cc injectors are all you will need. I would have saved the money on the radiator as the stock one is fine. I'd forgo the KYB's and springs and saved for legit coilovers.
GTOJOE
10-25-2011, 10:46 PM
FYI
http://www.3sgto.org/f2/15g-dyno-results-396awhp-@-gzp-4426.html
FedsGTO on 3si claims to have 470whp [on pump] on 15G's but he hasn't posted a dyno graph.
Are you running 13g's or 15g's?? - 3000GT/Stealth International Message Center (http://www.3si.org/forum/f1/you-running-13gs-15gs-511888/)
VR-4 0wnz j00
10-27-2011, 04:31 AM
What do you think the limit is? I wanted to go with 660's because I wanted to have room if I wanted to run race gas. I already made the mistake with 450's, so I dont want to have to buy injectors again. Should I get anything for timing control? Just trying to figure out the best way to do this.
Ray Pampena
10-27-2011, 12:10 PM
im making 525whp with the 550s.. incase that helps
GTOJOE
10-27-2011, 08:00 PM
im making 525whp with the 550s.. incase that helps
Is that on your DR650 car? and is that pump?
VR-4 0wnz j00
10-31-2011, 10:52 AM
im making 525whp with the 550s.. incase that helps
Thanks Ray, is that on pump or race gas?
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.