View Full Version : part number for outputshaft seal!!!
Sin'sVr4
09-27-2011, 10:08 PM
My output shaft seal must have gotten damaged when we put the tranny back together becasue its leaking pretty bad. anyone have one or know the part number? I need to get this fixed. car is running very strong, but this stupid leak is making me not drive it.
Sin'sVr4
09-27-2011, 10:09 PM
for a 5 speed 25 spline
MajorWedgee
09-28-2011, 09:13 AM
Mr110306
Sin'sVr4
09-28-2011, 11:47 AM
thx got it!
green-lantern
09-28-2011, 12:51 PM
That sucks, it’s so easy to do. We were very careful when we did mine but tore it anyway. I was able to pull the trans back from the engine far enough to get the old one out. I then used a plastic pluming piece (tube) that was for a sink to knock the new one in. From now on when I do one I’m just going to put that seal in after I get the trans back together.
Sin'sVr4
09-28-2011, 12:54 PM
ya thats what jfast told me too. same thing. we're gonna do it when he gets time i guess. just sucks all that for that little thing to tear. ugh....
green-lantern
09-28-2011, 06:32 PM
I was beyond pissed :D
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.