NotMaiCar
09-19-2011, 06:51 PM
I plan on putting my motor and tranny in this week sometime. The only things I still need are the bolts for tranny to engine, and to do the CAS swap.
I haven't done a lot of searching on this first part because I'm not quite sure how to word it to actually get results. I need to get the thread pattern specs. for the bolts that hold the tranny to the engine. The motor is a '94 DOHC N/A. I looked through a few of the service manuals on 3SX and can't find where it would be, so if anyone can tell me, I'd appreciate it.
Second, I'm putting the motor in a '92 frame so I need to relocate the CAS to the throttle blade side of the plenum on the rear head. Although I can't see how the sensor can bolt onto anything in that area, or how it even fits in place. Does anybody have a picture of exactly what holds it in place? When I put it under the valve cover it sticks out a good bit, so obviously I'm missing something.
Thanks guys.
I haven't done a lot of searching on this first part because I'm not quite sure how to word it to actually get results. I need to get the thread pattern specs. for the bolts that hold the tranny to the engine. The motor is a '94 DOHC N/A. I looked through a few of the service manuals on 3SX and can't find where it would be, so if anyone can tell me, I'd appreciate it.
Second, I'm putting the motor in a '92 frame so I need to relocate the CAS to the throttle blade side of the plenum on the rear head. Although I can't see how the sensor can bolt onto anything in that area, or how it even fits in place. Does anybody have a picture of exactly what holds it in place? When I put it under the valve cover it sticks out a good bit, so obviously I'm missing something.
Thanks guys.