PDA

View Full Version : HOW TO: 2nd gen alarm disarm



x2xtreme360
09-13-2011, 11:20 PM
I know this has been covered in many threads. The only issue I found was that there was very little info covered for 2nd gens. The first gens have a light green wire at the etacs that disarms the alarm system. From what I've found, 2nd gens (at least my 97) don't have this wire.

I used an alternate, yet just as simple method, to disarm the alarm system in my 97. The idea is only partly mine. I got the idea from this thread (http://www.3si.org/forum/f1/howto-disable-factory-alarm-confirmed-1st-2nd-gen-396194/). I just didn't want to do it in the trunk area, so I just did it right at the etacs.

My dash was out when I did this, which makes it easier, but even with it in it's still a piece of cake.

First, locate the blue wire with the red stripe. It's on the top plug of the etacs, pin #20 (very end of plug on top). Cut it and leave an inch or two.
http://i89.photobucket.com/albums/k226/X2Xtreme360/GOPR1071.jpg

2nd, wire in a length of wire, solder, and heat shrink or tape it up.
http://i89.photobucket.com/albums/k226/X2Xtreme360/GOPR1073.jpg

3rd, locate a good ground and be sure that the other end of the wire can reach and have some slack as well. Crimp and solder a ring terminal.
http://i89.photobucket.com/albums/k226/X2Xtreme360/GOPR1075.jpg

Last, secure the terminal to your ground location with either a stock bolt or screw. My location was there when I bought the car, but I don't believe it is stock. It definitely works though, and is nearby.
http://i89.photobucket.com/albums/k226/X2Xtreme360/GOPR1076.jpg

And that's it. No more annoying alarm. All this does is grounds out the liftgate lockswitch all the time. In other words, the car alarm would disarm when you unlocked the car... this is the same concept, except it's always grounded.

Why did I do it this way? In the other method above, you grounded it at the lockswitch. You can no longer use the lockswitch as a trigger for anything. Using my method, you can reuse the other end of the cut wire at the etacs harness for an aftermarket alarm that might have a disarm function when the key unlocks the trunk! This method also doesn't affect any of the other functions that the etacs provides, which is awesome.

Gearheadvr4
09-14-2011, 10:15 AM
Thank you for this. As s Spyder owner I couldn't use a trunk switch. I wonder if this will work for me? Would the wires still be there but not used?

Jimvr4
09-14-2011, 05:22 PM
I hate guides that recommend cutting stock wiring. I think someone got into your wiring before you owned the car and the only reasonable solution for you was this.

I have my aftermarket alarm wired in parallel with the stock system, no cutting and no disabling required. I never arm the stock system because I only use the aftermarket fob to lock/unlock the car.

Gearheadvr4 - there's no wiring to the liftgate lockswitch since we don't have one. Meaning you could just ground the wire mentioned without any cutting required.