View Full Version : 9b HP numbers
GTOJOE
06-18-2011, 11:27 AM
I see Austin@STM has managed 373AWHP on stock 9b's and stock engine internals. Has anyone else managed numbers close to this? if so what are your mods?
Cheers,
Joe
Bluejediz
06-18-2011, 04:48 PM
Looks like Trevor made 359AWHP on 9b's: Dyno Chart Collection Thread, Take Two - 3000GT/Stealth International Message Center (http://www.3si.org/forum/f35/dyno-chart-collection-thread-take-two-396270/)
Ive found other people saying they made 360+ but no dyno charts.
Its common to get into the 320 range...but most people who want more dont bother and just get bigger turbos lol
GTOJOE
06-18-2011, 11:47 PM
That number was an estimate not an actual on dyno figue. However that link is very helpful thank you. WSRTT hit just over 350WHP on 9b's [but running high octane fuel]
Nationalmilkman
06-18-2011, 11:53 PM
Any numbers on a N/A to TT conversion? Would the higher compression help or hurt? I've always been an N/A guy so I don't know.
J-Groove
06-19-2011, 12:00 AM
Any numbers on a N/A to TT conversion? Would the higher compression help or hurt? I've always been an N/A guy so I don't know.
Higher compression is a double edged sword. You can make more power on less boost, but you cannot run as much boost before detonation.
-John
ray got a customer's car to just over 300 whp with some good tuning on 9b's. i'd say if you're doing it right, 300 is a fair number. you're really struggling beyond that point though.
9b's are best for n/a motors--given the compression limit. you can probably hit 350+ whp with 9b's on an n/a engine...but i don't think anyone's ever taken that setup to the limit. and regardless of which engine you use, 13g's are almost a no-brainer upgrade from 9b's for "bottom rung turbo". spool is almost identical & there's much more potential.
p.s.
i never heard about wsrtt getting 350 whp on 9b's. that must have been back when keith was running the shop.
GTOJOE
06-19-2011, 05:16 AM
Hmmm I won't be happy with only 300whp. I might just fit all the fuel stuff and do a street tune then get it done properly when I can afford some DR goodness or failing that 19T's
Or I could try to break the 9b record :lol:
19t's are great, but there's a wide range on the market (as the other thread attests to). billet 650's are a pretty decent bang for the buck currently.
what holds the 9b's back is CFM. it's a matter of pure, hard science. 9b's just cannot put out more air than they're designed for. you can crank the PSI up at lower rpm's, but they'll gas quicker in the RPM band. in extreme form, this means that above 5k rpms your HP starts dropping.
on a side note, i've sometimes wondered about 14b's. granted, there are very, very few 3s'ers who have ever utilized them. i also don't know if they utilize the same housings. still, putting billet wheels in a 14b td05 would likely give you the absolute fastest-spooling td05 solution for our cars, bar none. coupled with a stroker you might even be be spooling below 2k rpms (pure conjecture).
WSRTT
08-16-2011, 12:28 AM
that was before we ever the shop and he had not really ever touched my car
ray got a customer's car to just over 300 whp with some good tuning on 9b's. i'd say if you're doing it right, 300 is a fair number. you're really struggling beyond that point though.
9b's are best for n/a motors--given the compression limit. you can probably hit 350+ whp with 9b's on an n/a engine...but i don't think anyone's ever taken that setup to the limit. and regardless of which engine you use, 13g's are almost a no-brainer upgrade from 9b's for "bottom rung turbo". spool is almost identical & there's much more potential.
p.s.
i never heard about wsrtt getting 350 whp on 9b's. that must have been back when keith was running the shop.
Hans@GZP
08-16-2011, 10:16 AM
We had a stock turbo stealth make 324 awhp with an open downpipe, SAFC, 450cc injectors and a hot wired fuel pump... I believe it was running around 18 psi.
We've had some turbo conversion (10 to 1 motors) making 309 fwhp at 9 psi, 250 awhp at 9 psi (through an awd auto trans), and we had one running e85 and like 16 psi, but I forget the numbers... I think it was around 360 fwhp.
vr3.9
08-16-2011, 10:54 AM
Isn't the most powerful 9b kinda like the tallest midget, smartest guy on the short bus or Strongest Old Dude on the Planet. :w00t:
Hans@GZP
08-16-2011, 11:19 AM
Isn't the most powerful 9b kinda like the tallest midget, smartest guy on the short bus or Strongest Old Dude on the Planet. :w00t:
derp..
Isn't the most powerful 9b kinda like the tallest midget, smartest guy on the short bus or Strongest Old Dude on the Planet. :w00t:
Just so...
mike hit the nail on the head.
Boomer3000
08-17-2011, 04:44 AM
Go either 15g's or 13t's. Mike is making awesome power on his 13t's and a local(to me) stl3s guy is running 15g's and ran 12.5 at the Ng(First timer on the track with the 15's). But either way its one of the better options to make good power and not have to switch from bolt on to custom Tdo5 madness. All mods on the 15g car talked about in my post were Performed/installed by Morgans Motorsports
93SlugTT
08-17-2011, 06:54 AM
15gs are good for deep 11s.
familyMAN
08-18-2011, 01:01 AM
Hmmm I won't be happy with only 300whp. I might just fit all the fuel stuff and do a street tune then get it done properly when I can afford some DR goodness or failing that 19T's
Or I could try to break the 9b record :lol:
Not likely. The STM car had AEM EMS, E85, a great FMIC, and good tuning on their dyno. For less $, you could have billet DR650s, Maft, stock SMIC, and stock exhaust and make 100+ hp more.
GTO Assassin
08-18-2011, 09:41 AM
I got around 330AWHP with a few mods and my shitty 9b's. Tuner said the turbo's weren't very good - close to cactus. lol
Scotty
GTOJOE
08-18-2011, 09:29 PM
What type of dyno Scotty?
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.