View Full Version : oil cooler headache
mb7050
04-12-2011, 10:49 PM
small problem rely but
So i have a fluidyne 12x11x2.7 oil cooler with fixed Male -10 AN fittings and russell proclassic Female -8 AN hoses and fittings/hose ends.
its way too late and i cant think straight :w00t::eh::confused2::shake2:
Anyone know can I buy -10AN fittings/hose ends for -8 AN hose ?
Russell Performance - ProClassic Adapter Fittings (http://www.russellperformance.com/mc/proclassic/adapters.shtml)
i could use -10 AN Female To -8 AN Male Flare Reducer but it seems to be very hard to find sellers that would ship international fuck..
/problem solved had to pay 50$ for shipping for two 10$ fittings aint that reasonable priced shipping...lol
i bought all of my fittings for my fuel system off ebay. you can occasionally find sellers who are willing to ship international--without too much hassle.
mb7050
04-13-2011, 08:45 AM
thats what I did too bad shipping is always prity expensive
Hans@GZP
04-14-2011, 06:22 PM
If you bought a GZP oil cooler you wouldn't have this problem :)
mb7050
04-14-2011, 06:49 PM
i know but I had this fluidyne cooler laying around
If you bought a GZP oil cooler you wouldn't have this problem :)
you guys didn't have 2"+ thick cores with fans. ;)
Hans@GZP
04-15-2011, 01:51 PM
I could use a core like that. But I don't think there is much of an advantage there unless you are a dyno queen.
I could use a core like that. But I don't think there is much of an advantage there unless you are a dyno queen.
my whole build is overkill. by design. :)
no offence, there are better ways :p
slighly less wide intercoolers....so you can mount them slighly further forward so you can fit a pair of oil coolers on the very back closest to the wheel well...make them as large as you can fit (without making them too thick that they start radiating heat back into the IC's)
mb7050
04-16-2011, 05:43 AM
inperfect Finland.
next question should I add a fan or not..
no offence, there are better ways :p
slighly less wide intercoolers....so you can mount them slighly further forward so you can fit a pair of oil coolers on the very back closest to the wheel well...make them as large as you can fit (without making them too thick that they start radiating heat back into the IC's)
i've got a massive front-mount. the sides are only for the fluid heat-exchangers.
I have a massive front mount too, but mine's not thick enough to require additional assistance pushing air through it :p
I have a massive front mount too, but mine's not thick enough to require additional assistance pushing air through it :p
i think you're misunderstanding me.
i have a FMIC. i'm going to run SMOC and SMTC's; each 2-3" and with a fan.
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.