PDA

View Full Version : Idle still itteremittent...



Sin'sVr4
03-22-2011, 01:54 PM
OK, so went home, took the front krank vent off and installed a pcv to see if the idle changes. started it up this morning and went to 2000rpms. took the idle screw down and got rpms to about 1000-1100 rpms. steady...

Took off to work and got to a light and rpms stayed at 2000. went to get gas, same thing. pulled into work and dropped to normal 1000-1100.. wtf? i adjusted the throttle cable and it wasnt tight, no slack. checked the cruise control box springs and all were good tension. idk? wtf?

btw,this started after yesterday i was warming the car up and pulled the throttle cable and it came off the track and reved to 6000 rpms (my 2 step) and wouldnt shut off till i turned off the car.

Nytron
03-22-2011, 02:04 PM
First thing to check is a bad/dirty IAC/ISC valve, see this link: link (http://www.stealth316.com/2-isc-iac.htm)

There are 6 pins on the IAC valve, you need to check the resistance between each pin. Should be between 28-40ohms. When mine went bad I had no reading between pins 4 and 5. $69 part from rockauto.

Sin'sVr4
03-22-2011, 02:38 PM
sweet. i will take it out and test it tonight. i will clean it too

Sin'sVr4
03-22-2011, 04:05 PM
am i measuring the pins on the IAC or the pins on the connector?

Nytron
03-22-2011, 04:10 PM
am i measuring the pins on the IAC or the pins on the connector?
See step #2 in the link I posted above. You measure the pins on the IAC.

http://www.stealth316.com/images/isc_conn.jpg
src: stealth316.com

RL7
03-22-2011, 05:50 PM
If the IAC checks out good, you'll probably want to set your idle to make sure something isn't way off. If you have a datalogger, make sure the idle flag is coming on when you are at idle and take a look at the ISC steps- it will let you know what may be going on there. It sounds like you may have a pretty big vacuum leak somewhere. A boost leak test could help you with that.

Sin'sVr4
03-22-2011, 10:07 PM
Ok, well just did the test...btw i have a new IAC motor on there, the black one, and all pins tested great...39.3, 39.7, 39.4, 39.8. Checked all lines and pipes and everything is pretty tighr and connected. Couldnt hear any leaks but tough when the engine is running :( ok, well, I will hook up my laptop tonight to the EMS and look at it. See what my reading are. BTW, what is normal with the ISC log? How do I do a boost leak test with dejon blow thru setup

Lugnut
03-22-2011, 10:28 PM
I had this problem for a minute after I did the injectors and I swore the cable was tightened in the correct spot, but on a double take it had slid just a touch which was enough .. For what its worth I also made a mark so I know at a glance

Sin'sVr4
03-23-2011, 02:22 PM
Since last night she is perfect again. no idle issues at all. After checking the IAC I unplugged the battery for about 1 hr, plugged everything back and car has been perfect. wonder if the morning it freaked out and reved to 6000rpms messed with the air sensor or something. But, good to go for now

Boomer3000
03-23-2011, 06:23 PM
Great to hear Sin... Keep us posted if that shit comes back man....

FeaRpb
03-23-2011, 06:45 PM
Damn just read the thread. I was going to tell you to unplug the battery for awhile. I have had this problem and so has a friend, and that seems to be the fix.

Glad to see you got it working.

Sin'sVr4
03-23-2011, 07:22 PM
Ya thx guys. Just might of freaked ou the ems for a bit. she runs perfect. no complaints :) I'll keep you posted if it comes back

halibut
05-05-2012, 03:02 AM
I was going to tell you to unplug the battery for awhile. I have had this problem and so has a friend, and that seems to be the fix.


Long-term fix or short-term?

Turbo Beast
05-05-2012, 11:19 AM
Long term, its a ecm reset

halibut
05-05-2012, 05:33 PM
Interesting... in my case, I've been trying to solve an intermittent idle problem, and it seems that every time I disconnect the battery for any period of time, when I put everything back together, it seems to run nearly flawlessly. At first I thought I was actually solving the issue, but apparently not, because a day or two later the problem returns. I went ahead and left it disconnected for longer than a day, just reconnected it, and it appears to be running fine again. The problem is as follows:

a.) Sometimes doesn't idle at all without depressing throttle (which I suppose isn't really "idling", is it?)
b.) Sometimes idles back and forth between high and low rpms (Tachometer hasn't worked since I bought the car)
c.) ISC servo is perfectly dandy (I list it as a problem because, well, if it didn't work, then I could just replace it, and there would be no problem)

I guess I just need to go get some propane (or some sort of UV vacuum leak test kit) and check that before I go rambling on and on about my headache.
And also, I suppose I should try to clean the throttle body, as when I stuck my finger just bast the butterfly valve, it returned covered in soot (that can't be healthy). I think I should like to pick up some sort of proper cleaner for it, as the only cleaner I have now is designated as a "electrical component cleaner", and the throttle body isn't exACTly an electrical component.

halibut
05-05-2012, 05:38 PM
Oh, also:

c.) No consistent dash-light
i.) Sometimes AntiLock light comes on for some reason
d.) Had a friend with a (rare, DSM-compliant) datalogger at his work (which means I can only use it some evenings at exactly six pm), it connected at one point, but the next time (for whatever reason) it decided it wouldn't connect, so I can't really tell you if I'm running rich or lean, or anything like that. I sure wish I could. That would just be great.

vr4tune
05-05-2012, 06:04 PM
Sin is AEM EMS not a factory ecu!