PDA

View Full Version : Making this gauge work (electrical knowledge help required!)



Frostedbutts
03-05-2011, 04:20 AM
I'm looking to get a new oil pressure gauge, and came upon this in another thread (Thanks JasonY):

Automobile Multimeter for EGT, Boost, Amber [SYL-1813A] - $53.50 : auberins.com, Temperature control solutions for home and industry (http://www.auberins.com/index.php?main_page=product_info&cPath=5&products_id=207)

I've fallen in love with it and now I need to make it work. It says


For water/oil pressure measurement, the meter can work with either old style resistive pressure sensor or the modern style pressure transducer with linear voltage output. The meter offers a regulated 5V DC output for the power supply of the pressure transducer.

So assuming our cars use either of these outputs (I have no idea, can they?) all I need is to wire the gauge in with a power, ground, and signal wire. If I use the stock sending unit - which is my hope - which color wire is ground, power, and which is source?

If our stock sender won't work, I had planned on using one of these senders and harness with an adapter, since it is so small in size.

Replacement Elite Oil Pressure Sender Unit (http://www.glowshiftdirect.com/replacementeliteoilpressuresenderunit.aspx)

Could I then feed three wires from that (power, source, and ground) into the unit and make it work?


tl;dr how do I make this beautiful piece of machinery work

speedy25
03-05-2011, 10:21 AM
The answer is resistance. You only hook up a wire from the gauge to the sensor. Power and ground get hooked to the gauge.

-SP

Frostedbutts
03-06-2011, 04:19 PM
The answer is resistance. You only hook up a wire from the gauge to the sensor. Power and ground get hooked to the gauge.

-SP

Thanks. Any idea which wire is the signal wire?