Need some help..

[Modern 3kGT]

So, I was feeling fairly proud of myself tonight. I don't have much experience working on cars but tonight I installed my new shifter and Shifter Assembly Stabilizer Bushing Kit. So yea I felt like I accomplished something!

I pulled it out of the garage to take it for a spin and get some gas, no more than 5 miles. Noticing it was having idling problems and then the check engine light came on. So I drove it home to figure out whats up. Apparently, I forgot to plug my freaking MAS back in. Total newb move I know.

But know after checking everything like 3 times its all back that way it was and idles fine but the check engine light is still on. Will the code just clear itself eventually or do I have to clear it? Or did i possible screw something else up?

Any help would be greatly appreciated... Thanks!

John

[Roybatty]

Congrats on install, Ecu can be reset by removing battery negative cable for over 10 minutes, you should have any radio codes documented.

[Austin@STM]

Yes after so many cycles it will clear itself. Or like said above, simply remove the battery terminals and then reconnect. This will clear everything.