PDA

View Full Version : Spun bearing club



Nationalmilkman
11-02-2010, 10:06 PM
Of all the bearings being spun in all the 3/S cars, what motor and what mileage are they letting go at?

CoopKill
11-02-2010, 10:19 PM
Not even going to look at the results! :suspect:

UTRacerX9
11-02-2010, 10:25 PM
Spun on a bearing on my first TT, at 59,8xx miles. Just barely under warranty still, thankfully. I had just bought the car about a month or two prior, so no telling what causes led to it. At the time, I was in 3rd gear going about 55-60 mph, or around 4k rpm IIRC.

My current car I bought with 51k on it about 10 years ago, now it has 91k, and is still running strong.

stealthee
11-02-2010, 11:20 PM
There is no set mileage they let go at. There are people at over 200k miles on the original engine. Its all in proper care.

I've only ever heard of 2 SOHC 3s's spinning bearings. I've got two spun bearing DOHC NA engines in my garage though.

MADMarc
11-03-2010, 12:13 AM
I bought my car w/a spun bearing and it sat at 147k. 150 seems to be about the average from what I've found on turbos.

Nationalmilkman
11-03-2010, 04:46 PM
Well I'm rolling 146K on my DOHC. Just wondering if I should watch it on how hard I drive it.

blindmist
11-03-2010, 04:49 PM
89k BUT I was running closed wastegates on my 9b's and I saw the gauge hit 20psi plenty of times.

colt45 gto
11-04-2010, 04:25 AM
i had 1 car spin a bearing that was a black GTO TT. and that was fault of my own. i cleaned the block off with a spining wire brush and un-knowingly dropped a couple of bristles down the oil way, one of these went through the oil pump and lodged in the pressure relief valve.

non of my others have ever suffered this, i'll post again when we come back from a europe tour, which i'm more than confident will go without a hitch on a motor thats covered 166,000 already.

blindmist
11-04-2010, 04:40 AM
i had 1 car spin a bearing that was a black GTO TT. and that was fault of my own. i cleaned the block off with a spining wire brush and un-knowingly dropped a couple of bristles down the oil way, one of these went through the oil pump and lodged in the pressure relief valve.

non of my others have ever suffered this, i'll post again when we come back from a europe tour, which i'm more than confident will go without a hitch on a motor thats covered 166,000 already.

166,000KM or Miles?

You should have a unit disclaimer in your sig. :lol:

Chris@Rvengeperformance
11-04-2010, 06:32 PM
Well I'm rolling 146K on my DOHC. Just wondering if I should watch it on how hard I drive it.

if you want to keep it for a long time and avoid the bearing fairy then install a new oil pump and bearings.

1stStealthN/A
11-05-2010, 12:28 AM
I bought a 92 Stealth ES DOHC years ago with a spun bearing at 132,000 miles but it was severely abused. The oil was like tar. It's not neccessarily miles but maintenance.

AshyBone
11-09-2010, 06:31 AM
Its also how you treat the car. I got mine when I was 17. 1 race against a modded WRX and a launch off redline latter I met the bearing fary. Car was dead and bounced from shop to shop for 2 and a half years.
I'm kinda happy it died when it did and i got screwed over how I did. If none of that ever happened I may not be as mechaniclly inclined as I am today.... What the fuck am I saying its a VR4 I'd become a mechanic after three break downs if the bearings didn't go...

CoreyB
11-09-2010, 11:10 AM
Mine spun at 169,000, but that was at the drag strip and my oil pressure had always been low. But I pushed her anyway. She's all happy again now. I wont push it again until I have a logger.

TwIzTeD_3kGt
11-09-2010, 11:16 AM
VR4 @ 125k, running lean @ 130mph in 4th is when it let go. Had a lean condition for a while prior though (didn't know at the time).

ChargerX3
11-09-2010, 02:19 PM
Must admit that this is one club that im happy to not be a part of. FWIW my TT's have made it to 275k,210,100k respectively.

TwIzTeD_3kGt
11-09-2010, 05:33 PM
Must admit that this is one club that im happy to not be a part of. FWIW my TT's have made it to 275k,210,100k respectively.

You are not welcome here.