Need help wiring SAFCII into VPC harness

[akotten]

OK, so I wanted to wire up my SAFCII into my VPC's harness and prepare it for installation. Only thing is, I'm still a bit confused as to which wires from the VPC need to be intercepted by the SAFCII. My VPC only has a blue, red, white, gray, black, and brown wire (these are what the VPC plugs into). On the plug-n-play harness, there ARE a few yellow wires that stick out the side because they have fuses or transistors in them (little plastic enclosures).

Any help is greatly appreciated!


-Alex

[HellBringer]

OK, so I wanted to wire up my SAFCII into my VPC's harness and prepare it for installation. Only thing is, I'm still a bit confused as to which wires from the VPC need to be intercepted by the SAFCII. My VPC only has a blue, red, white, gray, black, and brown wire (these are what the VPC plugs into). On the plug-n-play harness, there ARE a few yellow wires that stick out the side because they have fuses or transistors in them (little plastic enclosures).

Any help is greatly appreciated!


-Alex



This is specific to the Supra installation, but the general principal is the same:



http://www.97supraturbo.com/Tech%20stuff/VPC-SAFC%20Install.JPG



The VPC output wire (should be yellow) connects to the SAFC Input wire (white); the SAFC output wire connects to ECU harness the same as it would without the VPC.

If you have the plug n play harness, you may need to disconnect the yellow Output wire, as it comes pre-wired into the harness (thus 'plug n play'). That's the way I installed it on my Supra -- works perfectly. I leave the VPC zero'd and do all of the tuning through the SAFCII

I would have replied to you on 3si previously, but I'm suspended for a week.

[akotten]

Does this harness look familiar?

http://i361.photobucket.com/albums/oo56/akotten/655515859_photobucket_7747_.jpg

[akotten]

bump please