PDA

View Full Version : Intermediate shaft (jack shaft) identifications



stealthee
10-10-2020, 10:52 PM
Still going through all my parts again and I have 3 different intermediate shafts. All are 27 spline, but I have 3 different lengths. I know the ATX, MTX, and TT are all different lengths, but for the life of me I can't find how long each one is so I can list them properly. I remember someone posting a list with the lengths at one point, but I have looked everywhere and can't find it.

I measured from the outer part of the seal to the end of the shaft and these are the lenghts

12 3/4"
13 3/16"
13 5/16"

If anyone can't help me out I'd greatly appreciate it.

stealthee
10-10-2020, 11:16 PM
Ok, so I finally found something, but still want to find more info to make sure everything is good.

25" 3/4 (FWD)
24" 13/32 (AWD)

I'm assuming the FWD length listed is MTX, as well as both lengths are overall.

I'll remeasure tomorrow overall length and maybe hopefully we'll have an actual list instead of every post saying x shaft is longer than y.