PDA

View Full Version : Fuel Pump Assembly



GFreemenRT
10-20-2010, 08:53 PM
While installing my walbro, I had to fix the low fuel light wiring. Upon tightening down the nut, it snapped off from the assembly;

http://img148.imageshack.us/img148/123/img1967v.jpg


Are these posts replaceable, or is it a whole new assembly time?

Austin@STM
10-20-2010, 09:28 PM
I am not sure if you can get those exact ones again, but there are plenty of options to replace the wiring, without replacing the entire assembly.

J. Fast
10-20-2010, 10:34 PM
You can drill it and remove the insulation and install two electrical and fuel resistant bushings (SBR washers) on each side of the assembly. On top of each SBR washer install a stainless screw and nut with (4) stainless washers and split them with ring connectors (sandwich one ring from the top and another from the bottom). It will work just dandy for you.

Jeremy

J. Fast
10-21-2010, 12:20 AM
You can epoxy the repair after you test it for added protection.

terrets
10-21-2010, 04:29 AM
I would just drill a hole next to the post and run a wire through it and JB weld it :). When I broke mine off in my Talon a few years ago my mechanic just sodered the wire to where it broke...Not sure if thats an option for you.