PDA

View Full Version : gauges question



a2j
10-17-2010, 08:48 PM
I need the following: water temp, oil temp, oil pressure, and others...
I will be putting them them in the stock locations (oil temp will go in "boost" gauge location). Can I use stock send units or not? can I just take the stock gauges out and replace with aftermarket ones? I will need oil temp sender but what about oil pressure and water temp?

Mean Green
10-18-2010, 09:22 AM
You cannot use the stock sending units for aftermarket gauges. I wish.

a2j
10-18-2010, 11:48 AM
alright! next question... where would I put aftermarket water temp sending unit? best location. take out the stock?

Atrosity
10-18-2010, 12:20 PM
For my gauges, I used the stock location for oil pressure and water temp. I can't stress this enough but do not spend money on cheap gauges. You get what you pay for, including inaccuracy. Do it right the first time and buy reputable gauges. In the stock location I have aem 52 mm gauges.

deemo99
10-18-2010, 12:27 PM
I also highly recommend the AEM 52's. Very accurate, fast and not too bright at night.

a2j
10-18-2010, 08:06 PM
I was asking about sending units location, not the gauges themselves

Mean Green
10-19-2010, 06:04 AM
I used all stock locations. The coolant sensor your swapping out is the black pluged one. It doesn't really matter which oil unit you swap out.

deemo99
10-19-2010, 07:27 AM
You can also use a sandwich plate for oil temp and press.....

a2j
10-26-2010, 10:00 PM
if I will remove stock water temp sending unit to put in aftermarket, would that mess anything up? like signal to ecu or something else?