PDA

View Full Version : Meth and O2 wideband not working -wired into the AEM ecu



colossus
03-16-2015, 04:29 PM
I have been trying to troubleshoot and been tracing wires but meanwhile I hope you guys can give me some ideas...

the car has been set up so that If there is overboost or knock the AEM failsafe cuts out the boost controller and runs wastegate pressure. which is about 12lbs (running DR750's with upgraded wastegates). I noticed my AEM O2 wideband did not have power and also noticed some bucking the same day the wideband power went out. I shortly noticed they were directly related, but havent been able to find the root of the issue. I need my wideband and Meth working again ...thoughts??
-When everything starts up it appears the meth is on, I hit test and could hear the pump gurgle; so the meth pump is getting power.
- Greddy boost controller is also getting power and appears to be working correctly on start up.
-Wideband has zero power on start up -Power wire appears to tie into AEM loom
- have checked a few fuses that were added in- but they are so far fine

colossus
03-31-2015, 08:08 PM
After tracing everything and checking power at the gauge. I have found my AEM 02 wideband is getting power but the display randomly broke and stopped working. So 1 UEGO sensor lasted about 1 mile and the 2nd one about 600 miles (gauge).

Now I just need to know why the meth isn't squirting and my system is shutting off.....
I checked the lines which seem unpinched. Perhaps its actually a knock issue preventing the meth from even coming on and then shutting down??