PDA

View Full Version : Autocross 1st race of the season and 1st on the SCE diff. Vids inside.



R/T93
05-28-2014, 08:45 PM
Coopkill and Wingnut helped me put in an SCE center diff and my dad also welded in the Pampena brace a few months ago and I FINALLY have made it to an autocross since the install. The car drives soooo much nicer than before, under steer is reduced by half from before and the car isnt tail happy at all, very easy to drive hard.

I finally got my alignment sorted out too, but it isnt an all out race alignment. -1.4 degrees up front but the rear has -2.4 and a couple mm of toe out. The rear end is STABLE, however.

The Ohlins coil overs are superb, I added one click to the rear after my first run and it was noticeable, the car handles great even at full weight (probably 4k even with me in it).

I only took one pic of my car at the track.

http://i28.photobucket.com/albums/c201/Ultor2/20140526_082420.jpg

My first run was good, clean. 53.3. You can see some areas where I was already straightened out before making the next turn, these are the areas I could carry more speed on.

https://www.youtube.com/watch?v=gcd_2KiBBkI

My 2nd vid was much better. The timing equipment screwed up and I didnt get a time but I figure somewhere in the 52's. I had a 200 lb passenger. The slalom after the C-box got screwed up and was placed wrongly. I still ran through it the way it was set up before but it was now a detriment to my time. The course stayed like this for the rest of the day. The slalom could now be taken R/L/R for an advantage. I didnt know this yet though.

https://www.youtube.com/watch?v=WhAs4wRCSMc

3rd run was still tentative but a much better time, 51.8 and clean.

https://www.youtube.com/watch?v=BfmvuZF6STA

This was my best run of the day, my last run didnt record but it was dirty anyways, I entered the C-box way too hot and took out 2 exit cones, lol. This was just a smooth fast run with warm tires. There are a few small mistakes in there though I could have improved on but I am no professional. 51.1

https://www.youtube.com/watch?v=pdrweEP9W5M

I was spraying my sidemounts and intake manifold with a garden sprayer and icewater between all my runs. IC's would be 130's after a run and in the 60's before my next one. Same with intake manifold. I could half the end run temp of 160 before my next run with just a few applications of the water. Makes a big difference. i ran 13.5 PSI all day and never adjusted my tire pressures.

I noticed I still have front wheelspin, I didnt remember it on the track but apparently its still there :/ Sticky hot 255 Z2's still dont have enough grip for 9b POWAH!!

DocWalt
05-28-2014, 09:20 PM
needs more diff! I don't think the alternate route through the slalom was much, if any faster.

futurevr4man
05-28-2014, 10:44 PM
looks good gnat. needs more boost!

kywhitelightning
05-28-2014, 10:53 PM
Why toe?

Jeff

Edit: Is that what is induced with the camber plate adjustment or is it on purpose?

CoopKill
05-28-2014, 10:57 PM
If only surgery for the mrs was not to happen. I would be tearing my diff out... :(

Great to see it made things better! (and stayed in there) :suspect:

I am not gonna lie. I am jelly, and hatin right now!

R/T93
05-28-2014, 10:59 PM
Jeff toe helps with turn in and mid corner stability when used properly.

My fronts have only .5mm of toe, the rears have 4x that much with 2mm.

kywhitelightning
05-28-2014, 11:05 PM
Still utilizing AWS?

Jeff

R/T93
05-28-2014, 11:08 PM
Yes my AWS is completely operational and always will be :listening_headphone

CoopKill
05-28-2014, 11:09 PM
Did you get booted to a new class yet?

futurevr4man
05-29-2014, 12:28 AM
how did you compare to the other times ran?

R/T93
05-29-2014, 12:38 AM
Times havent been posted yet. I did well for a bsp car on street tires.

From the phone.

HLxDrummer
05-29-2014, 12:42 PM
I'm guessing you didn't get the front diff?

Glad to hear the center has helped you out. You can tell a difference watching these vids vs. your older ones. Your front tires will probably last a bit longer now lol!

I love how you are building the car "backwards" (turbos last). Awesome suspension and brakes, unbreakable drivetrain. Now just slap on a set of turbos and it will be the ultimate street machine!

PS Do you have a link to the rules for BSP? At my very first autox they told me I was in STX (maybe STU, can't remember) because of one modification. I want to say air filter or test pipe. Doubtful BSP will help me much though with all the Evos in that class!

kywhitelightning
05-29-2014, 03:17 PM
I don't think his car is built backwards at all. Matter of fact it is more a purpose built car. The fastest cars at the autox last year at the NG all had 13G or smaller turbos. This car was just flat freaking impressive going head to head with maddogs. Huge weight difference between the two and maddog was running 13G's I believe. I am really looking forward to seeing it this year with the new goodies.

Jeff

HLxDrummer
05-29-2014, 04:03 PM
I don't think his car is built backwards at all. Matter of fact it is more a purpose built car. The fastest cars at the autox last year at the NG all had 13G or smaller turbos. This car was just flat freaking impressive going head to head with maddogs. Huge weight difference between the two and maddog was running 13G's I believe. I am really looking forward to seeing it this year with the new goodies.

Jeff

I meant backwards from most people's approach. Most people throw turbos on before anything else. Trust me, I love his setup! Simple, clean, and purpose built.

CoopKill
05-29-2014, 04:16 PM
We tormented him for not doing the clutch, and front diff when doing the center diff. ;p

Unlogic
05-29-2014, 07:50 PM
Nice vids!

I have to get my car back together again so that I can continue testing my SCE diff too. I had some problems with noise from the gearbox during acceleration and engine breaking after installing the diff so I pulled the gearbox after just 50 km of driving to check that everything was okay. Has your gearbox remained as quiet as it was before you installed the diff?

R/T93
05-29-2014, 08:00 PM
Its quieter since my stock one was blown with loose spider gear pins

From the phone.

anyonebutme
05-29-2014, 08:30 PM
Dan as 13T turbos, basically a 15G

As I understand it aftermarket center and rear diff doesn't reclass the car because we already have a limited slip stock in those locations

I gave up with SCCA classing years ago. I've had tech inspectors class my car into 3 different classes depending on the day I showed up, lmao.

wingnut
05-29-2014, 10:03 PM
We will torment him for many moons, for not doing the clutch...

:wink:

R/T93
05-29-2014, 10:17 PM
Clutch smutch! Whatever is in there is still good, lol.

From the phone.

vroom4
05-30-2014, 06:43 PM
Dan as 13T turbos, basically a 15G

As I understand it aftermarket center and rear diff doesn't reclass the car because we already have a limited slip stock in those locations

I gave up with SCCA classing years ago. I've had tech inspectors class my car into 3 different classes depending on the day I showed up, lmao.

Because tech isnt responsible for classing your car, you are. Tech is there to make sure your car isnt a danger to you/anyone else.

vroom4
05-30-2014, 06:43 PM
Dude come to nwautox.org event at packwood June 14th.

green-lantern
05-30-2014, 06:51 PM
Garrett, where have you been hiding? rebawc?

vr4tune
05-31-2014, 04:36 AM
Nate I think you need a stroker engine for those 9B turbs!

CoopKill
05-31-2014, 03:01 PM
Nate I think you need a stroker engine for those 9B turbs!

:lmao:

wingnut
05-31-2014, 06:07 PM
Nate I think you need a stroker engine for those 9B turbs!

Pfffft...that thing almost fit into my pocket yesterday, and made a trip over the hill to my hangar :p

CoopKill
06-01-2014, 01:34 AM
Pfffft...that thing almost fit into my pocket yesterday, and made a trip over the hill to my hangar :p

:lmao:

Unlogic
09-14-2015, 12:18 PM
Have you noticed any difference in handling during engine braking since you fitted the sce diff?

My impressions so far is that the increase in rear wheel bias doesn't affect only acceleration but also engine braking. Apart from the complete spin out in the video below I've had numerous close calls when the rear end tries to brake loose during engine braking and high and medium speeds.


https://www.youtube.com/watch?v=vhX2cXGoi-c

R/T93
09-14-2015, 07:35 PM
I have spun like that but it has been driver error. I don't think the differential has made it more oversteery off throttle or mid turn. Rear suspension too stiff?

anyonebutme
09-14-2015, 09:16 PM
AWD cars have a natural tendency to lift oversteer, because it's basically trail braking itself. From what little I've ridden in SCE diff cars, the center actually increases off throttle understeer. It likes braking in straight lines and powering throughout the turn.