View Full Version : Drivetrain Reseal Transfer Case
hitman17
10-07-2010, 01:50 PM
I just bought the seal kit for the transfer case. I did notice that to seal the input and output shaft there is a press tool needed from Mitsu. Has anyone done this themselves? If so, what did you use to press those seals in? I assume it wouldn't take much, but I wanted to be sure.
Thanks.
MADMarc
10-08-2010, 12:55 AM
I know I have seen a walkthrough before that recommends alternative tools. If I can find it I will post up. Just writing this so you don't think nobody is tossing in ideas.
hitman17
10-11-2010, 05:34 PM
Anyone have info on this?
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.