Main clearances question

[Bloodlust182]

Hey guys, I just plastigaged my mains and the clearances came out to be .049~.053mm. I am using WPC treated clevite standard bearings with a standard sized forged crank that has been polished on a 2 bolt block. I have read that the clevite bearings tend to be on the loose fitting side, should i be ok?

[Chris@Rvengeperformance]

That's right around 2 thousandths. I can't see an issue with that.

[Bloodlust182]

Sweet, thanks for verifying. Now i just have to wait on parts from summit to assemble the pistons and plastigage the rods.