View Full Version : 6 speed shifter assembly spring location
Andr3w
07-06-2013, 01:08 PM
Removed my bellhousing to have the brace installed. I recall people mentioning a spring will drop when you pull out the linkage.
Below is a picture of the spring. I am rrying to figure out where it goes. I initally thought it went on the end of the shaft, but the shaft is too long.
http://img.tapatalk.com/d/13/07/07/bavehu7y.jpg
Sent from my SPH-L720 using Tapatalk 2
Jimvr4
07-07-2013, 11:15 AM
That spring and cylinder is part of the shift detent. There is a diferent spring that goes on the end of the shift shaft.
Andr3w
07-07-2013, 11:22 AM
Thanks. Luckily I dropped this thing down the tranny hosuing because I ended up finding the correct spring.
This piston and spring goes into the front dentent I am guessing. Is that correct?
Sent from my SPH-L720 using Tapatalk 2
Jimvr4
07-07-2013, 02:10 PM
Yes, part of the shift detent
J. Fast
07-08-2013, 01:10 AM
Removed my bellhousing to have the brace installed. I recall people mentioning a spring will drop when you pull out the linkage.
http://img.tapatalk.com/d/13/07/07/bavehu7y.jpg
Sent from my SPH-L720 using Tapatalk 2
Hey man' I see an expelled shift fork roll pin in there. Look at the shift fork on the far right... There's a fix for that in the drivetrain section... You're lucky you caught it in time.
Andr3w
07-08-2013, 10:37 AM
After finding out what that spribg and cylinder was, I found this pic in the other forum. Sure enough mine was missing and well.
http://img.tapatalk.com/d/13/07/08/2yqa4ymy.jpg
Sent from my SPH-L720 using Tapatalk 2
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.