sergechronos
06-25-2013, 11:59 AM
Was getting ready to flash the 1g PnP ECU today, however I noticed something and wanted to clarify before I did it.
My OBD1 to OBD2 adapter has the wires in slightly different places versus the demonstration images on the ChromedECU site, and I wanted to verify before having stuff get messed up. Noticed it because I was about to install the black reflash adapter piece from Tactrix with the 2.5mm plug.
Here's what I've got
White Side (from the side that goes into the OBD adapter), Clip on Top: 3 blanks, clip, red then yellow
White side bottom: Double black wire, blank, blue, 4 blanks
So looks kinda like
[ ] [ ] [ ] Clip [R] [Y]
[B] [ ] [B] [ ] [ ] [ ] [ ]
Black Side, Clip on Top: Red, 7 blanks
Black Side bottom: Blank, Yellow, blank, black, black, blank, blank, blue
These contrast with the images on the Site which shows the white side (OBD1 side) as being completely reversed, and my OBD2 side is at the very least out of order from looking at the image provided although I can't tell specific pin outs. Can someone confirm that this is okay and I just put my black reflash adapter piece in the slot opposite the yellow on the OBD1 side?
Incidentally, I'm getting a message when I pull up Evoscan that there's not 5V detected, not sure if it's related or not.
As a (hopefully) final update: The wires were out of order and had to be corrected on the OBD1 side. Pictures in the last post show the proper order for the pins on both sides.
My OBD1 to OBD2 adapter has the wires in slightly different places versus the demonstration images on the ChromedECU site, and I wanted to verify before having stuff get messed up. Noticed it because I was about to install the black reflash adapter piece from Tactrix with the 2.5mm plug.
Here's what I've got
White Side (from the side that goes into the OBD adapter), Clip on Top: 3 blanks, clip, red then yellow
White side bottom: Double black wire, blank, blue, 4 blanks
So looks kinda like
[ ] [ ] [ ] Clip [R] [Y]
[B] [ ] [B] [ ] [ ] [ ] [ ]
Black Side, Clip on Top: Red, 7 blanks
Black Side bottom: Blank, Yellow, blank, black, black, blank, blank, blue
These contrast with the images on the Site which shows the white side (OBD1 side) as being completely reversed, and my OBD2 side is at the very least out of order from looking at the image provided although I can't tell specific pin outs. Can someone confirm that this is okay and I just put my black reflash adapter piece in the slot opposite the yellow on the OBD1 side?
Incidentally, I'm getting a message when I pull up Evoscan that there's not 5V detected, not sure if it's related or not.
As a (hopefully) final update: The wires were out of order and had to be corrected on the OBD1 side. Pictures in the last post show the proper order for the pins on both sides.