Morgan motorsports intake manifold with 75mm tb

[mehrshadvr4]

selling manifold built by Morgan motorsports. it comes with ford flange accufab TB and tps. the throttle respond with this setup is unreal off boost. the car moves so easy and respond so nice with it. the manifold is polished where it's exposed, but it's a bit dirty. i'll clean it out before shipping it. i just didn't have time to do it before taking pic. it comes with different fittings for bosters and such so you don't have to run T fitting on it. asking $850 shipped obo.
https://sphotos-a.xx.fbcdn.net/hphotos-ash4/300717_10151583075303594_1990411207_n.jpg
https://sphotos-a.xx.fbcdn.net/hphotos-prn1/74468_10151583075763594_955422522_n.jpg
https://sphotos-a.xx.fbcdn.net/hphotos-ash3/577440_10151583088268594_914881272_n.jpg
https://sphotos-b.xx.fbcdn.net/hphotos-snc7/253696_10151583088438594_749335626_n.jpg

[mehrshadvr4]

bumpppppppppp

[mehrshadvr4]

Cleaned it up a little.
http://i108.photobucket.com/albums/n13/mehrshad/intake2_zps3163fa39.jpg
http://i108.photobucket.com/albums/n13/mehrshad/Intake1_zps29402de9.jpg

[paulfisler]

is it shorter then the stock one aka do i need to take it off to do the back plugs

[95gto]

This manifold uses stock runner length, so you would have to remove the manifold to get access to the rear plugs.

[mehrshadvr4]

Yes the manifold needs to be removed. I just don't know how often do you even change spark plugs? It's not like you are running high boost all the time and need to change plugs so often. My car made well over 420whp on dyno dynamic and I never had to replace the plugs when I chose the right plug for it. Just run the basic coper NGK plug gap it to .22-.24 and you'll be good to go.

[FWombat]

Do you still have this for sale?

[mehrshadvr4]

Sorry it's sold.