View Full Version : NHRA altitude correction factors
Sin'sVr4
04-16-2013, 12:48 AM
NHRA altitude correction factors (http://www.nhra.com/competition/altitude.aspx?AspxAutoDetectCookieSupport=1)
Im Pueblo, CO
R/T93
04-16-2013, 12:51 AM
Umm, they are correction factors.
Multiply your ET by .9508 and your MPH by 1.0466.....
Sin'sVr4
04-16-2013, 01:02 AM
ya I figured it out lol saw this chart too...http://www.hardtail.com/techtips/altitude.html
so based on these, at 4900 ft compared to sea level, in Pueblo CO 4900 ft I ran 12.00 @ 113
the nhra says I ran a 11.40 @118 and the hard rail says 11.27 @120
Didn't realize its THAT huge difference
J. Fast
04-16-2013, 08:01 AM
ya I figured it out lol saw this chart too...http://www.hardtail.com/techtips/altitude.html
so based on these, at 4900 ft compared to sea level, in Pueblo CO 4900 ft I ran 12.00 @ 113
the nhra says I ran a 11.40 @118 and the hard rail says 11.27 @120
Didn't realize its THAT huge difference
11.7 seconds in Denver and 11.5 seconds in Pueblo is a 10 sec car at altitude. 10.5 sea level quarter mile cars don't even break 10's at altitude... try like 11.2+ seconds. You need about 600 to the wheel here to crack off 10's in a 3700lb car. SAE corrected... that's somewhere in the 700whp range at sea level. Also, boost taper is huge here. Tiny hotsides just can't spin enough air out. You'll never see a TD-04 crack 10's they just can't produce the power here. The best 1/4 time I've ever documented on TD-04's was 11.4 @ 123.
The 0.7 added to ET is pretty standard.
In 2010 I ran 11.6@ 120mph and 11.4@ 123mph on 19T's. Here's the video's
11.6 run... Video_090910_002.mp4 Video by JFastMotorsports | Photobucket (http://s788.photobucket.com/user/JFastMotorsports/media/Colorado3s/Video_090910_002.mp4.html)
11.4 run... Pump Gas 11.4 @123 Video by JFastMotorsports | Photobucket (http://s788.photobucket.com/user/JFastMotorsports/media/Colorado3s/Video_092110_002.mp4.html)
According to the NHRA tables they would have likely translated to somewhere in the vicinity of 10.9@ 127mph and 10.7@ 130mph at sealevel. Mehh... I owned a 10 sec car 3 years ago... she's waaay faster now. Altitude sucks! If it makes you feel better no one on the board who owns a 10.5 second or over car could break-out of the 11's here. I'd actually bet a pretty hefty stack of cash on it.
Chris@Rvengeperformance
04-16-2013, 12:18 PM
You guys realize that Matt set his records at 3600ft?
J. Fast
04-16-2013, 10:15 PM
Hate to bust your bubble but the track in TX is still 0.4 faster than Denver IF the DA in Denver is actually 6000ft above sea level (which it never is). It's usually around 7500ft above sea level. In that case congrats you'll run atleast a half second slower. A 10.8 car in Amarillo, TX will run a 11.3 in Denver all day long without any changes. Hate to break it to you guys but DR750's would never break 600 uncorrected horsepower here. They wouldn't even crack 500 to the wheels.
Here's some results on what takes place here...
I posted this in feb of 2012. This is my NABR Co-Driver's car from Rally North America, Hal. This car was Dyno'd @ MAC Autosport in Denver on a Dynojet. It put down 600 uncorrected. The car was driven to sea level and put right back on a Dynojet and it made 750 uncorrected. NO changes were made to the setup.
http://i788.photobucket.com/albums/yy163/JFastMotorsports/HalsDynoAltitudevsSeaLevel.jpg
Soo, Ray P makes 650 uncorrected at the wheels on DR750's with heads and a built motor and run's 10.6's at sea level. Here, according to real world data he would likely make 490 uncorrected and run an 11.3. I would wager $1000 dollars on that dial in and even pay with a breakout. More than likely with a 7500ft DA the numbers would be in the range of 11.5 seconds.
Chris@Rvengeperformance
04-16-2013, 10:21 PM
well let's just say what you are saying flies in the fast of all of matt's drag racing actual experience and leave it at that.
If it makes you guys feel warm and fuzzy great, but I believe in actual timeslips.
J. Fast
04-16-2013, 11:15 PM
I totally get the driver effect, Chris. The results depicted aren't about driver tho. It's all laws of physics. Ofcourse you can get that "X- Factor" out of a driver but a 750whp car and a 600whp car just don't drive the same if all else is equal. You can't expect the same 1/4 mile results with real world info out there like this.
I sometime wish DJ's had an altitude option wherein you could enter your "traveling to x elevation" information and they would spit out the net result. It would really help with turbo and cam selections on high and low altitude setups.
R/T93
04-16-2013, 11:28 PM
Umm, the laws of physics say exactly what Sin's first link says.... thats from the given data over tens of thousands of runs over thousands of cars.
RealMcCoy
04-17-2013, 12:08 AM
This same conversation is going on over on 3Si... Matt posted in it earlier.
There is a difference... Just not as big for turbo cars. The NHRA corrections are for N/A cars... look at the classes they correct. There are no forced induction cars there. Most real correction calculators have different factors for N/A and forced induction. But they include blowers in the same category as turbos. You don't just turn up the boost on a roots blower, you have to swap pulleys to change how much air it pumps.
An air density variation that would knock a second off an N/A motors time, would likely be less than half that on any forced induction motor, and maybe even less on a well set up turbo car.
Matt said he used to gain a couple tenths going to sea level with his old 11 second cars. That is pretty consistent with the more accurate calculators, and would likely equate to 4-5 tenths if he went from sea level to Mile High...
The OP has previously stated that the altitude density factor for his 12.00 runs was upwards of 8000ft. If that's so, it's very believable that he would run a mid 11 with sea level air... An N/A under the same circumstances would drop to 10.70's easily.
Sin'sVr4
04-17-2013, 12:26 AM
woa guys, just posting the conversion table for shits and grins. Yes it makes me feel warm and fuzzy, yes my air density that night was a whopping 8000ft. Do I care that matt ran 8's sure. But, I am not trying to prove anything about anyone or anyones setup. Just saying at higher elevations my car is slower than the sea level guys.
3500ft is still ALOT lower than 5000ft.
DuTTch
04-17-2013, 01:35 AM
NHRA altitude correction factors
I kept reading NRA attitude correction factors lol, finally got it today.
J. Fast
04-17-2013, 10:48 AM
This same conversation is going on over on 3Si... Matt posted in it earlier.
There is a difference... Just not as big for turbo cars. The NHRA corrections are for N/A cars... look at the classes they correct. There are no forced induction cars there. Most real correction calculators have different factors for N/A and forced induction. But they include blowers in the same category as turbos. You don't just turn up the boost on a roots blower, you have to swap pulleys to change how much air it pumps.
An air density variation that would knock a second off an N/A motors time, would likely be less than half that on any forced induction motor, and maybe even less on a well set up turbo car.
Matt said he used to gain a couple tenths going to sea level with his old 11 second cars. That is pretty consistent with the more accurate calculators, and would likely equate to 4-5 tenths if he went from sea level to Mile High...
The OP has previously stated that the altitude density factor for his 12.00 runs wasupwards of 8000ft. If that's so, it's very believable that he would run a mid 11 with sea level air... An N/A under the same circumstances would drop to 10.70's easily.
Cool. I dont waste time over there so I had no idea. The graph I posted is off a 2G Turbo DSM. The uncorrected power loss going to and from elevation is right at 25%. These are real world uncorrected results. Quite often we see skewed results which paint an unrealistic picture of results. If Matt believes he can take a 550 uncorrected whp car at sea level and run 10.9's and then drive to Denver and net a whopping 400 uncorrected whp and he's only going to lose a half second then so be it. I've results which dispute the outcome and they're from a legitimate source. The test was conducted by English racing and NABR Generals. If you visit the DSM community and research the 8 second list youll find they commission the fastest Mitsubishi's in the world.
J. Fast
04-17-2013, 10:57 AM
See this link...
http://www.dsmtimes.org/times.php?Page=1
The colum on the right in Red... My Rally North America co-driver is the general of NABR. I believe everything he tells me about going fast.
vroom4
04-17-2013, 11:37 AM
You sure do bitch about altitude a lot, maybe you should just move haha.
Chris@Rvengeperformance
04-17-2013, 11:43 AM
Cool. I dont waste time over there so I had no idea. The graph I posted is off a 2G Turbo DSM. The uncorrected power loss going to and from elevation is right at 25%. These are real world uncorrected results. Quite often we see skewed results which paint an unrealistic picture of results. If Matt believes he can take a 550 uncorrected whp car at sea level and run 10.9's and then drive to Denver and net a whopping 400 uncorrected whp and he's only going to lose a half second then so be it. I've results which dispute the outcome and they're from a legitimate source. The test was conducted by English racing and NABR Generals. If you visit the DSM community and research the 8 second list youll find they commission the fastest Mitsubishi's in the world.
you don't waste time over there because you're banned under several usernames.
The only time altitude is going to kill a turbo cars performance is when the turbos are absolutely maxed out at sea level. The majority of us don't run our turbos at 100% duty cycle, so there is some extra airflow to compensate for the altitude changes.
Sin'sVr4
04-17-2013, 01:22 PM
you don't waste time over there because you're banned under several usernames.
The only time altitude is going to kill a turbo cars performance is when the turbos are absolutely maxed out at sea level. The majority of us don't run our turbos at 100% duty cycle, so there is some extra airflow to compensate for the altitude changes.
Forrest that is kind uncalled for.have u ever driven your car at 5-6000 ft? Jer is showing proven statistics. If u haven't driven up here then stop chiming in. This wasn't to be a bash session on anyone. I enjoy racing and I know others do too. This was to just give some insight on elevation factors. Minga
Chris@Rvengeperformance
04-17-2013, 01:28 PM
You two need to get married you flop back and forth so much. I can't keep straight if you hate him or not on a given day.
I just find offense to someone acting like they are too good for a site they were banned from for posting bullshit on.
familyMAN
04-17-2013, 02:32 PM
^ :D. Just subscribing to drama. The CO boys know how to deliver...
Sin, I do sincerely hope your car does well at the strip this year.
Sin'sVr4
04-17-2013, 04:35 PM
^ :D. Just subscribing to drama. The CO boys know how to deliver...
Sin, I do sincerely hope your car does well at the strip this year.
Well, I really hope so too. Lol.
Forrest, I don't hate anyone. Understood what your saying. But the ponit of my thread was exactly what it states. Didn't want a drama thread
J. Fast
04-18-2013, 12:06 AM
Lol, Behnken reminds me of my brother.
donniekak
04-18-2013, 03:46 AM
Forrest that is kind uncalled for.have u ever driven your car at 5-6000 ft? Jer is showing proven statistics. If u haven't driven up here then stop chiming in. This wasn't to be a bash session on anyone. I enjoy racing and I know others do too. This was to just give some insight on elevation factors. Minga
I have. Turning up the boost netted me the same performance in flagstaff as in Phoenix. Had my turbos been maxed out I would have lost noticeable power. Unless you are against the choke line on your turbos map, you can compensate for altitude with more boost.
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.