View Full Version : TPS position on Evoscan? Also, idle switch on/off?
smartaxel
04-03-2013, 09:44 PM
Started the 92 with 99 ECM for the first time and the idle is high (no fault of the ECM - it was like this beforehand). When I look at at EVO scan, when the foot is off the pedal, and viewing the "full dashboard" gauges, they show the TPS an entire notch above the "0" mark. I tried to adjust it, and even with the TPS fully loose and turned all the way, it does not zero out or go to the bottom of the "Gauge". Do yours show at zero? Or is this normal? Also, should evoscan show the "idle position switch" in anything but 0 when you try to adjust the TPS? Figured I could use that flag to properly adjust the TPS but it never changes. The TPS is not original to this car, it came from a parts car, so it could very well be bad.
Thanks folks!
Prizefighter
04-04-2013, 03:33 AM
What is the actual number in the log? I know my TPS reads 12.1% and I think I remember reading the range being between 10-14% at idle.
Patryn
04-04-2013, 01:13 PM
If memory serves me correctly around %12 is normal. I was using EVO Scan as well to set my TPS, but it was a while ago.
Boostaddict
04-04-2013, 01:14 PM
I don't think evoscan shows proper idle switch operation in either of the chrome versions I've tried. Greg has mentioned this to me before, but I haven't followed up on it yet. That isn't to say the idle switch isn't working... its just that evoscan isn't showing it.
Kx1984
04-04-2013, 01:40 PM
I remember reading the range being between 10-14% at idle.
^^^^^
Yep
Chris@Rvengeperformance
04-04-2013, 02:28 PM
I don't think evoscan shows proper idle switch operation in either of the chrome versions I've tried. Greg has mentioned this to me before, but I haven't followed up on it yet. That isn't to say the idle switch isn't working... its just that evoscan isn't showing it.
The idle position switch in evoscan isn't set for our cars. Go to that line and set "x bit 128 to x bit 1".
12% is fine for the TPS
KeithMac
04-04-2013, 03:03 PM
Idle switch will definitely be on at 12% tps, mines 14.5% with idle switch set correctly.
dbest671
04-04-2013, 03:55 PM
From my experiences... the tps is usually between 12.5%-14.0% when I set them for the rebuilds.
smartaxel
04-04-2013, 09:41 PM
Thanks to everyone for the responses! Mine was a bit under 14% -good to know that's normal! I tested the idle switch with a meter and it was working but not on evoscan. I didn't realize I needed to make that shance for it. I'll make the evoscan changes tomorrow and give it a shot.
Powered by vBulletin® Version 4.2.3 Copyright © 2026 vBulletin Solutions, Inc. All rights reserved.