PDA

View Full Version : Chrome V2 and GM MAF



DarkHeroKOTRAJ
01-10-2013, 12:50 PM
I am just making the move from my current setup of factory 93 ECU with G-Reddy Ult to the new Flash ECU with Chrome V2 and I had a question about MAF options. I have the GM MAF sensor and GM MAFT all ready with AEM AIT (from my under standing the numbers are just about the same as the factory) and was going to go that way instead of the EVO MAF, but I had a question in regards to how you set it up with the knobs; should I leave them at the stander 360 injector setting with no other correction or some other combination (if so I am assuming you are using different options in Chromed config?)

Posted at the request of Greg

Chris@Rvengeperformance
01-10-2013, 01:12 PM
best way is to use the ecu to scale the injectors and set the maft to 360s. It is still going to be off quite a bit, but you can fix it with the ve table.

Greg E
01-10-2013, 01:19 PM
I question the AEM sensor scaling being the same as stock. With a little research I can find out for sure. If you do use the AEM AIT make sure it goes into pin 62 of your flash ECU. You can splice it into the MAF harness plug in the engine bay too. The next version of chrome will have a smaller table than the stock 131 element AIT scaling table for easier setup.

The two cars I tuned with the MAFT I just left the unit zeroed out. You still gotta set the dip switches for the correct GM MAF that you're using though. Even without changing anything in the VE table, both cars fired right up like stock. Tuning the VE and fuel table was the same as with a stock/EVO MAF.

You leave all the knobs at zero because you don't want the device to correct the readings at all. Since the ECU now will know your exact injector size and dead times there's no need to alter the signal anymore.

I did find it rather peculiar that the MAFT showed less airflow than what I was used to seeing. Not that it really made any difference because you tune the tables for the airflow you log. Just an observation is all. This might be a good thing with high HP cars because there's a pulse limitation in the code. If the MAF shows less airflow than there actually is, then we can get more air thru the motor before reaching that limitation.

DarkHeroKOTRAJ
01-10-2013, 02:29 PM
That is what I thought, but wanted to check on this it be certain that you had not made any other changes that would make that MAF work different/better.