Aluminum/Steel Driveshaft

[Blacktoptt]

What I have is a 5 speed PST Aluminum/Steel Driveshaft that I pulled from my stealth that I sold off a few years back and prob have no need to hold onto it any longer as all I have is 6 speed cars now ..it's in good shape and was only used about 10k ...asking $600 shipped

http://i84.photobucket.com/albums/k29/blacktoptt/010-7.jpg

[green-lantern]

Good deal

[Streamln1]

very tempting

[Blacktoptt]

^ you should buy it

[Blacktoptt]

I want some money for a project I'm working on...Let get this sold

[IPD]

too bad it's not 6-speed. :(

[Blacktoptt]

:bump:

[Chris@Rvengeperformance]

It will work in your 6 speed. It just wont go in the transfer case quite as far

Sent from my DROIDX using Tapatalk 2

[IPD]

that's what i'm worried about.

[Blacktoptt]

I wouldn't run it on one of my 6 speed cars since it it a 5 speed shaft but the buyer can make that call

[Chris@Rvengeperformance]

I mean have you physically installed it? I have had a 6 speed shaft in both transmissions. The difference is not that great. I'm just trying to get you to not waste money if you don't have to.

[Chris@Rvengeperformance]

that's what i'm worried about.

once you have 1 diameter of the splines of engagement anything extra does nothing for you if your motor mounts are decent. The shaft goes in practically a mile into the 5 speed transfer case. I wouldn't worry.

[IPD]

i'm thinking more along the lines of the short length vs the atx transfer case it fits into. i don't have any experience in that area (plus i'd hate to find out that i can't get my nipple spliced onto it...but that's another concern entirely).

[Blacktoptt]

..sold..