- Woot! A place to talk flashing etc.!
- My new Flash Tuned Build thread... will need advice :) 94 Stealth TT
- SL ECU Major Differences or Why NOT to Use an SL ECU
- What do you tune for?
- Best Engine Management for 98 16G built car
- Just ordered my 98 VR4 ECU :)
- Parameters you can mod while tuning with flashed ECU's
- md347251 ECU (98 DOHC) on ebay 149$
- Electronic Boost Controllers
- Custom Flash Service?
- Another ECU on ebay 347251 98 sl
- EMS Starting And Tuning Help Please
- 100 buxs to whoever gets my car running EMS
- If I'm to find a desirable ECU for the anticipated...
- My tune drifted lean...Why?
- Just received the MAFT Pro
- My preemptive tuning problems thread
- Need SAFC-11 settings
- Tuning Basically Stock Car
- Tuning for E85
- If remote tuning possible with AEM EMS or someone to build a startup calibration
- 880cc PTE Injectors, ECU Flash, and a 1998 3000GT VR4
- datalogging for dummies
- Maft pro
- S2 EMS Load Transition Breakup Problem
- mmcd tools
- ECU Flash Tuning : The Basics
- Zeitronix ECA for "true" Flex Fuel E85 tuning?
- arc2 and e85
- ** How to CORRECTLY tune your Apexi AVC-R **
- WANTED> Basemap EMU, 20gs, 750cc, speed density
- AEM Pinouts
- Who rebuilt your ECU and would you recommend them?
- MAFT Setting with DR-750s
- ECU Capacitors took out C6
- Evo 560 Latency Values
- maft/mas tuning help needed in GA please
- Disassembly: Knock and Octane code
- AEM S2 and serial guage
- Disassembly: Lean Spool
- Disassembly: Startup fuel tables
- Disassembly: Ignition Trim Tables
- Disassembly: Radiator Fan Control
- no spark no fuel
- Disassembly: Speed Limit
- Disassembly: Stock Boost Gauge
- Disassembly: Closed Loop/Fuel Trims
- Disassembly: Manifold Pressure Differential Sensor
- no communication through obd1 diagnostic port (datalogger AND lcdboostcontroller)
- Mitsu flashable TT ecu and ecu repair
- G/I: True Antilag for flashable ECU
- Anyone wanna look at my DSM Log?
- AEM ems: P/I control?
- Tuning help w/ Neo AFC
- AEM EMS Banter Thread
- Are there any Known faults with AEM S2
- AEM EMS acting weird
- What 1000cc Injector is the best?
- Aem EMS 2 and Coolant Temp Sensor
- Vortec fmu/sfmu
- ECUflash Injector Scaling and Latency
- MAFT GEN2 Help, Q's and MAF over run or Bad Maf?
- 91 NA Base...no fire to spark plugs
- Help installing EMU
- sequential ignition
- O2 sensor problems... please help
- VR4 Weird Electrical Problem / Radio Shuts off
- AEM/OEM wiring
- Need Help !!!
- Fixed bucking & stuttering issue
- Temp sensor issue
- I need help with apexi safc2
- Official ARC-2 Settings Thread
- 91 VR4 no spark, no fuel
- Blitz DSBC users - your settings?
- 97 ECU in a 94 VR-4
- Disassembly: MAF tables and Air Flow Calculation
- Disassembly: Idle
- MAF Flow rates and info
- Map data from blitz dsbc
- Check Engine Light Flashes When Stopped??
- How to tune your 3/S using Chrome and a Flash ECU
- Chrome V2 Tech Manual
- Disassembly: Fuel Tables
- o2 sensors and fuel trims
- CoopKill haz Chrome questions...
- Open ECU update (ecu Flash)
- tactrix 2.0 problems...
- More scaled inputs
- Chrome V2 download issues
- Trying to add v2
- cant change periphery bits
- A New Technique for Tuning AEM Fuel Maps
- Chrome V2 and GM MAF
- Evoscan logs, wrong data in columns
- Chrome tuning questions
- 1 byte logging
- Chrome 2.1 hype
- Pump Gas Limitations
- ecu housing swap
- Idle Adjustment
- Who's who in flash ECU
- EVOScan questions
- Ignition Timing Thread
- So who is running MAFT + Chrome?
- Old school Pro-M with Chrome
- ecuflash problems
- MMCD Tool users when converting to Excel
- Bricked ecu members(need your help)...........clone from 99vr4(Brett)
- Flash ECU general questions
- Euro spec flash ecu immobilizer
- Specific ECU FLash tuning questions
- Chrome ECU tally & feed back
- AEM Tip in tune issue
- Ecu testing
- J2534 Read Error / Error 16
- Settings for 92 CAS when running 99 Clone ECU?
- Regarding our MAF and the MAF translator with chrome
- Couple of 99 Clone pinout questions
- Can't get evoscan to check for codes.
- Timing question
- MAC BCS revisited
- Tuning out rich condition on decel/blowoff
- So I went to start tuning the ecu and...
- Logging Oil and Fuel pressure thru the ECU
- O2 sensor questions
- Running a gutted stock MAF with the flash ECU.
- Jester Chrome ECU for 91-93 "Pins" Thread
- vr4 cutting/Running Issues. (Logs in side)
- ECU Controled Active Areo via custom Pin 48 output
- 2 chrome mods that will never happen
- Logging Evoscan 2.6 for DTC (CEL) with newer ecuflash
- Chromed ECU - Questions to running E85 (NA, 6G74)
- closed loop CEL
- Another VD Dyno thread. "stock" VR4
- Tactrix 2.0 won't read- Sending init sequence 2? Suggestions
- Chrome/Boost Control/Alcohol Injection
- Replacement wiring harness connectors
- TPS position on Evoscan? Also, idle switch on/off?
- Manual or Automatic Boost Gauge?
- CEL Code 53 No Spark Coil 3&6
- chrome speedo fix?
- Chrome Tuning Large Injectors
- Available "Pins"
- Random stuttering/stumbling
- Running rough with Flash ECU
- ECU Problems
- Tactrix data logging
- Using a 99 Clone ECU in a 91
- chrome clutch mods
- PnP ECU Flash Connector
- logging wideband issues
- Evoscan logging on my 99vr4 with Tactrix.
- Booboo with Active Exhaust in chrome V2
- Rc injector latency
- G1 Link ECU
- NLTS & CEL on knock problem
- How to set your idle with Chrome (the proper way)
- What is wrong with my ECUflash/EvoScan?
- How to tune your fuel trims with Chrome
- Stock MAF PPS limitation
- Chokes off after shifting under boost
- Sputtering/Power loss over 14psi
- Please help me get started
- strange CEL
- Tuning 19t's on 93 pump
- Car runs after a year of working on it, first time with Chromed ECU
- Chrome Launch control settings
- EVO 3-Bar MAP sensor voltage scaling
- Viewing Evoscan logs in Logworks: Evoscan2Logworks converter tool.
- Standalone ECU questions.
- CEL on, no codes stored?
- Just a couple of flash questions...
- Pressure in gas tank
- Over Boost fuel cut values?.
- 96-97 Fuel control
- having temp sensor issue with aem v2
- Vehicle Inspection Emmisions FAIL
- Logging fuel pressure
- Integrating chrome with an in dash display?
- 3.5L NA w/272's and Chromed ROM
- Help with PnP Ecu Into 1G GTO
- chrome for n/a
- OBD1 to OBD2 Adapter Pin Out
- Fresh Build + Flash ECU Tuning Experience
- Getting a CEL with no code? Read this...
- Chrome on a single o2 car
- Fans won't turn on unless commanded through Evoscan --- converted 93VR4
- Flash limit?
- Front Bank STFT Maxed out Rich-Suggestions
- Car will run for 5 seconds then shut off
- Spark question
- Chrome Tuning and Oxygenated Gas
- Chrome - blown hose limp mode?
- Pin 93 for wideband output
- Blip of 28 counts of knock/pop, what caused it?
- Another stupid injector question
- Launch Control/Anti-lag help
- NGK AFX Wideband issue
- Euro Spec '99 Flashable ECU in a '91 GTO
- Stock MAP sensor to log boost below 14.5psi?
- wbo2 Gauge and Evoscan Datalogs not completely in sync...
- quick theoretical question on AEM EMS scaling
- LTFT Low / VE question
- Evoscan q and datalog q
- OpenPort 2.0 + Chrome logging without laptop
- My car is running "pig rich"
- Controlling Boost with a Flash ECU?
- Comparison of 93 and race gases on oil dilution/damage.
- E85 now wont start
- o2 sensors in chrome
- car dies intermittentlly dies right after starting
- Car wants to die at idle. Not adjusting for desired target idle.
- Dejon "blow thru" y-pipe needed
- HELP! I think I bricked/stuffed my FlashECU :(
- Chrome ECU for TT conversion
- Tuning my 3sx executioners
- Help with tuning injectors I have it half way done. Please chim in.
- No fuel trims in evoscan?
- Getting ready to Dyno my DR750s, some timing related questions
- GMAF w/ Gen II translator help
- How to calculate instant MPG?
- Just an FYI, compare flashecu configs with EcuFlash since version 1.42
- Speed Density in the works for flash ECU?
- No boost, is it in the tune?
- first flash with chrome, runs poor/lean
- What input sensors does the ECU read in closed loop vs open loop? Stutter/no power
- Warm startup idle 'hunting'
- What's going on with Greg and the next version of Chrome.
- FlashECU Sensor Scales
- Anyone in SE PA need me to setup their chrome ECU?
- Flash ECU O2 Sensor Issue
- AEM load calculations?.
- Where to buy 3.75" MAF?
- CEL under WOT with AEM EMS2
- Using Baro input for MAP sensor on AEM Series 1 (a heads up!)
- Evoscan connectivity issues
- Getting good idle with 1200's on AEM Series 1?.
- EvoDroid7 Datalogger
- 99 euro ecu support
- Help with 93 to 91 engine conversion, and RDH to LHD
- GM 3 Bar MAP Install
- EvoScan 2.9 .net v2.0
- Question Regarding Fuel Trims
- Let's Talk Timing Maps
- Stock timing map
- '91 with recent plug and play clone (Jesters)
- Evoscan / Chrome xml / 94 hybrid Datalogging problems
- Turbo questions- situation
- Clutch with 13t