I have installed my O2 sim and have it working, but I have a question. There is one pin on the o2 sensor wiring that is left untouched.
It is the heater ground
My question:
I installed the sim without the o2 sensors (because I didn't have them). I cut the stock connectors off and wired the sim up... but I LEFT the heater grounds connected to nothing (instead of it being connected if the o2 sensors were still attached). Is this going to throw the functionality off? I'm not sure where the heater grounds even go to. They showed no continuity to ground when I tested with my DMM, so I don't even think they're a ground at all. Someone please verify?
Bookmarks